User manual LIFT-MASTER 376LG

[. . . ] Operation: Opener activates when 4-digit password and Enter button is pressed. If wrong numbers are accidentally pressed, correction can be made immediately. The Enter button will transmit only the last four digits. The Keypad will blink for 15 seconds after the password is transmitted. [. . . ] Within 30 seconds, enter a four digit personal identification number (PIN) of your choice on the keypad. Release the button when the motor unit lights blink. If light bulbs are not installed, two clicks will be heard. LOCK LIGHT LOCK LIGHT Side two contains instructions for installing the Keyless Entry, changing the personal entry password and setting a temporary password. 1 INSTALLATION Choose a convenient location for installation. Exterior Front Wall Install out of the reach 1-Piece or of children at a Sectional Door minimum height of 5 Door Jamb Edge feet (1. 5 m), away from (Optional Location all moving parts of door. for 1-Piece Door) For a one-piece door, Door Jamb Face choose the optional SECTIONAL DOOR ONLY location shown in the KEYPAD MUST BE INSTALLED illustration to avoid WITHIN SIGHT OF THE DOOR injury as the door swings up and out. Test the reception of the Keyless Entry by operating your opener from the selected location. Remove the battery compartment Bottom cover to access the bottom mounting hole mounting hole: · Insert a small phillips screw driver Battery into the small hole at the bottom of Battery the cover and gently pull Cover outward to loosen. · Slide the cover down to remove. Center the keypad at eye level against the selected location. Mark 4-1/4" up the centerline from the bottom and drill a 1/8" pilot hole. Install top mounting screw, allowing 1/8" to protrude above surface. Position keypad on screw head and adjust for snug fit. With cover open so bottom mounting hole is visible, use a punch to mark hole. Remove keypad and drill 1/8" pilot hole. Replace keypad and complete installation with bottom screw, using care to avoid cracking plastic housing. To replace the battery cover, insert the lip at the top and snap in place. Keypad Typical Installation TO CHANGE AN EXISTING, KNOWN PIN If the existing PIN is known, it may be changed by one person without using a ladder. Press the four buttons for the present PIN, then press and hold the # button. Press the new 4-digit PIN you have chosen, then press ENTER. The motor unit lights will blink once when the PIN has been learned. Test by pressing the new PIN, then press ENTER. [. . . ] SPECIAL NOTE: The temporary password can ONLY be programmed to keypads working on a Chamberlain or LiftMaster Garage Door Opener. It WILL NOT work on keypads programmed to an external receiver. THE KEYLESS ENTRY BATTERY WARNING To prevent possible SERIOUS INJURY or DEATH: · NEVER allow small children near batteries. · If battery is swallowed, immediately notify doctor. The 9 volt battery should produce power for at least one year. [. . . ]