User manual LIFT-MASTER 65LM

[. . . ] If incorrect numbers are accidentally pressed, a 5 second interval is necessary before starting over. Power Supply: Operates from the garage door opener power with a battery back-up for code memory and lighted keyboard. STEP 1--SECTIONAL DOORS: Draw two intersecting lines on garage jamb face - horizontally at eye level and vertically as close to centerline as possible. Make sure there is at least 1-1/4" clearance on each side of the vertical Line. [. . . ] For service Information call Toll Free: 1-800-528-2817 NOTE: If your garage has a built up jamb, drill the hole 2" deep. Then, on inside edge of jamb, drill a second hole into first hole to complete access. 1/8" Pilot Hole 1" Dia. Hole 2" Deep Cable 6ABx1-1/4" Screw Door Opening Inside Garage Wall Inside Edge of Jamb STEP 4: Position console on an interior garage wall approximately one foot from outside edge of door. Run bell wire up wall and across ceiling to garage door opener terminals. On current line Chamberlain models, connect wire to red and white opener terminals. On older models, connect to terminals used for push button controls. Connect to terminals used for push button controls. STEP 5: Pry open front panel of console with a coin or screwdriver. Snap a 9 volt battery onto circuit board connector and drop into console. DO NOT replace panel at this time. STEP 2: Hold keyboard firmly with the back of the case UP. Position thumb against bottom of case and pull up sharply. Keyboard will lift out of cover, allowing access to bottom mounting hole. Guide the keyboard cable through hole to inside the garage. Position the keyboard against outside jamb. Drill two 1/8" pilot holes for fastening screws. Attach securely with (2) 6ABx1-1/4" screws. Excess cable can be folded and inserted into the access hole to keep it out of the way. Console Front Panel Console Push Button Program/Operate Switch Bell Wire Transformer Terminals 3 2 1 Bell Wire (To Garage Door Opener) Connector Guides PRO GRA M E OPE RAT Batte ry Console Terminals Transformer Model 95 To 120V Outlet Cable STEP 3: Connect the 2-strand bell wire to terminals labeled 1 and 2 on back of console. Insert keyboard cable connector into slot on side of console. [. . . ] Move the program/operate switch to OPERATE position (the keyboard light will go off). NOTE: If you have Installed Transformer Model 95, plug the transformer Into a 120 VOLT outlet. If the door operates properly, replace the front panel on the console. Loss of power to either the battery or the garage door opener will not affect the programmed code. [. . . ]