User manual LIFT-MASTER 67LM

[. . . ] Do not allow children to operate the wall push button(s) or remote control(s). A moving garage door could injure or kill someone under it. Activate the opener only when you can see the door clearly, it is free of obstructions, and is properly adjusted. Features For use with any Security Plus TM compatible garage door opener receiver. Personalized Code: Up to 10, 000 possible combinations. [. . . ] After the opener lights blink, release the Enter button. Test by pressing the the code, then press Enter. You may also program the Keyless Entry from the door control, as follows: 1. With the door closed, enter the four digit code desired, then press and hold Enter. Press and hold the light button on the door control. Press and hold the door control push bar. After the opener lights blink, release all buttons. Garage Door Opener Receiver (With Smart Button) 1 2 3 Installation Typical Keypad Sectional Door Choose a convenient Installation location for Exterior Front Wall installation. It should 1-Piece or Sectional Door be at eye level, reachable by the Door Jamb Edge shortest person who (Optional Location will use it, and within for 1-Piece Door) sight of the door. For Door Jamb Face a one-piece door, SECTIONAL DOOR ONLY choose the optional KEYPAD MUST BE INSTALLED WITHIN SIGHT OF THE DOOR location shown in the illustration to avoid injury as the door swings out. Plug Open the keypad cover and remove the battery compartment screw and cover. Installation typique Hold keypad firmly with the d'une porte articulée cover half open so both top and Mur avant extérieur Porte rigide ou articulée bottom mounting holes are Bordure étroite visible. Use a punch to mark du montant de porte each hole. Drill two 1/8" pilot (emplacement en option pour les portes rigides) holes. Fasten securely with Battery Face du montant Battery screws provided. PORTE ARTICULÉE SEULEMENT Cover Insert the plug provided into the LE CLAVIER DOIT ÊTRE POSÉ DE FAÇON top hole to cover the fastening screw. LA PORTE SOIT VISIBLE DU CLAVIER QUE Reinstall the battery, matching the + and ­ markings on the battery compartment. Refasten the compartment cover. AVERTISSEMENT ATTENTION 9 AB C 1 7 3 5 9 7 5 3 1 2 GH I 1 DE F 4 MN O 3 JK L 6 TU V 5 PR S 8 0 KG EN TE R KG Changing the Personal Entry Code Press the four buttons for the present personal entry code, then press and hold the 0 button, then press Enter. Récepteur d'ouvre-porte de garage The opener light will blink twice. (avec bouton Smart) Press the new 4-digit1code you have chosen, then press 2 3 Enter. The opener light will blink once when the code has been learned. Test by pressing the new code, then press Enter. [. . . ] Test by pressing the four buttons for the temporary entry code, then press Enter. If the temporary code was set to a certain number of openings, remember that the test has used up one opening. Battery The 12 volt battery should produce power for approximately one year. As long as there is adequate power, the keypad will illuminate and the opener will operate when the correct entry code is pressed. [. . . ]