User manual LIFT-MASTER 72LM

[. . . ] The Wire-in Control consists of two parts: the power supply and the receiver. It can replace either single pole (1 switch controlling a single light) or 3way switches (2 switches controlling a single light). Depending on the 3-way switch wiring, light may turn on after a power failure. If properly wired, this will not occur with a single pole switch installation. [. . . ] If box is plastic, connect wire to metal part of Wire-in Control. SINGLE POLE SWITCH Fold the BLUE power supply wire back as shown and cap with wire nut. Screw nut in clockwise direction to secure. Cap black control wire to one junction box wire and red conrol wire to the other. Screw wire nuts on clockwise, making sure bare wires are covered. 3-WAY SWITCH Start by capping the black control wire to the COMMON "hot or live" wire; the red and blue control wires separately to the other two junction box wires in any order. Screw wire nuts on clockwise making sure bare wires are covered. _________________________________________________________________________________________________________ 7. Carefully pack the wiring back into junction box. Make sure wires are not pinched or strained. Fasten power supply to junction box with the #6x1-1/2" flat-head screws provided. Move receiver slide bar so "OFF" is visible. Position wall plate over the junction box. Align receiver so that three-pin plug engages holes in power supply and slide bar engages the power supply switch. Insert (2) #6-32x1-1/2" screws through fastening holes in receiver, wall plate and power supply. Tighten securely. Do not replace the actuator push button until you have set the code. See instructions below. POWER SUPPLY RECEIVER ______________________________________________________________________________________________________ PROCEDURE FOR SETTING OR CHANGING THE CODE The Wire-in Control receiver and transmiter must be set with matching codes. To set (or change the code for any reason follow instructions below. The receiver code switches are located on the front of the unit, behind the actuator. The switch code block with plus (+), (0) and minus(-) positions provide 19, 683 possible code settings. WITH MULTI FUNCTION TRANSMITTER Follow instructions packed with your multi function transmitter. [. . . ] · You are pressing the transmitter push button selected to operate Wire-in (on multi function transmitters). · Transmitters battery has power. NOTE: Test light on the transmitter should glow when push button is pressed. (Battery changing information is included in instructions packed with your transmitter). Series 53 Multifunction Remote Transmitter Series 74 Appliance Control Receiver Module Series 71 Indoor/Outdoor Receiver Module CAUTION: TO AVOID ELECTRIC SHOCK, move the slide switch to the OFF position whenever It is necessary to change a light bulb. [. . . ]