User manual LIFT-MASTER 73

[. . . ] NOTE: Each push button on the remote control can activate one or more remote control devices, including any 19, 683 code garage door opener. Follow code setting/changing instructions below before installing wall mount case. 3-Button Remote Control with Wall Mount Model 73 Users Instructions WARNING To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door: · ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or play with remote control remote controls. [. . . ] Beginning with RECEIVER code switch #2, match position of each remote control switch. If you have additional receivers, match the code settings of the remote control (2 through 9) and slide receiver code switch #1 to the position which matches an unused push button. NOTE: For receivers with less code switches than remote control, set excess remote control switches to the center (0) position. NOTE: Code switches 2 through 9 on all receivers operated by this remote control must match switches 2 through 9 in remote control. CAUTION: If you press more than one push button at the same time, remote control will not operate. WARNING To prevent possible SERIOUS INJURY or DEATH from electrocution, disconnect power to opener BEFORE proceeding. WARNING NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of this receiver and/or remote control are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Remote Control Circuit Board Push Button (-) 2 34 56 78 9 IO+ Push Button (0) Battery Push Button (+) Remote Control Code Switches 2 34 56 78 9 IO+ IO+ Receiver Code Switches 1 2 34 5 6 78 9 INSTALL WALL MOUNT Remote control range will vary depending on your house construction. Metal lath, foil-backed insulation or aluminum siding will reduce range. Before permanently installing wall mount on an interior wall, test the remote control operation at various locations within your home for convenience and range. If any push button will be used to operate a garage door opener, choose a location out of reach of children. Position wall mount and mark both fastening locations. Plastic anchors are provided, if required for your installation. Drill 3/16" holes and insert the anchors. [. . . ] Set aside top of case and discard old battery. Replace the top of case and the connecting screw. Replace visor clip. 114A1100B © 2006 The Chamberlain Group, Inc. [. . . ]