User manual LIFT-MASTER 772LM

[. . . ] · Remove screws holding switch to junction box. · Pull the switch from the junction box to access the connecting terminals. At this point, determine if you have a single pole or 3-way switch and follow the instructions that apply to your situation. Figure 1 Power Supply 6 -32x1-1/2" Screw Single Pole Switch Instructions, Figure 3: · Disconnect wires from the junction box switch. Straighten the ends to make sure the insulation is trimmed back 1/2" to allow connection of the power supply wires. [. . . ] · Fasten power supply to selected junction box location with the #6x1-1/2" flat-head screws provided. · Move power supply switch to the right as shown in Figure 5. Move receiver slide bar so "ON" is visible. The control will be ON when power to circuit is applied. Position wall plate over the junction box. Align receiver so that three-pin plug engages holes in power supply and slide bar engages the power supply switch. Insert (2) #6-32x1-1/2" screws through fastening holes in receiver, wall plate and power supply. Do not replace the actuator until you have set the code. See Side 2. Power Supply Switch Figure 4 Figure 5 O N Black Wire Red Wire PROGRAM Receiver Slide Bar PowerSupply Power Supply Receiver Install Jumper Wire for 3-Way Switch Applications Only, Figure 6: · Remove switch plate and screws from second 3-way switch. · Identify wire #1 previously connected to the red control wire in Figure 4. Loosen the terminal screw holding wire #1 just enough to install one end of the jumper wire. · Loosen screw at either of the two other terminals and install other end of jumper wire. · Reinstall switch and turn power back on. Turn Light Control on by moving the slide lever to ON position. Try operating the light using the second (remote 3-way) switch. · If light does not operate, TURN POWER OFF at fuses or circuit breaker and remove the remote 3-way switch. · Rewire the jumper to go from the wire #1 terminal to the other terminal. · Reinstall switch and turn power back on. Both the remote switch and the Light Control should now be able to control the light. Set Receiver to Match Remote Control(s) Code: Turn on the power to circuit at fuse box or circuit breaker. Select a remote control push button to operate the Light Control. · Press and HOLD the remote control push button. [. . . ] Review the wiring instructions for Single/3-Way Switch. · You are pressing the remote control push button selected to operate the light control. NOTE: Test light on the remote control should glow when push button is pressed. (Battery changing information is included in instructions packed with your remote control. ) CAUTION: To avoid electric shock, move the slide switch to the OFF position whenever it is necessary to change a light bulb. [. . . ]