User manual LIFT-MASTER DAMP ENVIROMENT

[. . . ] Refer to page 2 & 3 of addendum for electrical box replacement parts. Refer to page 4 of addendum for control and power wiring connections for damp environment applications. For all other installation instructions refer to owner's manual provided with operator. WARNING CAUTION When you see these Safety Symbols and Signal Words on the following pages, they will alert you to the possibility of serious injury or death if you do not comply with the warnings that accompany them. [. . . ] Mounting plate Transformer, 115/230 Volts Transformer, 460 Volts Transformer, 575 Volts Relay 24 VDC 600 DPST (A & B relay) Relay 24 VDC SPDT (1 Ph unit only) (C relay) Relay 12 VDC SPDT (3 Ph unit only) (C & D relay) Radio block Enclosure with cover Logic board RPM sensor Antenna Limit switch Sprocket 48B18 x 3/8" Sprocket 48B9 x 3/8" (CGT only) 20-3075C-4T 20-3075M-5T 20-1100B-2TLP 20-3100B-4T 20-100C-2TLP 20-3100C-4T 20-3100M-5T 20-1150C-2TLP 20-3150C-4T 20-3200C-4TP 20-3200C-5T 2 REPAIR PARTS KITS - ELECTRICAL BOX LOGIC CONTROL 3 K1 (K75-12515-1) 10 9 7 3 12 4 5, 6 2 1 K2 (K72-33192 & K72-33258(CGT) 13 8 11 3 ING ON R E C O M M E N D E D P O W E R WARNINGT R O L C O N N E C T I O N S AND CON WARNING To reduce the risk of SEVERE INJURY or DEATH: · ANY maintenance to the operator or in the area near the operator MUST not be performed until disconnecting the electrical power and locking-out the power via the operator power switch. Upon completion of maintenance the area MUST be cleared and secured, at that time the unit may be returned to service. · Disconnect power at the fuse box BEFORE proceeding. Operator MUST be properly grounded and connected in accordance with local electrical codes. The operator should be on a separate fused line of adequate capacity. · ALL electrical connections MUST be made by a qualified individual. · DO NOT install ANY wiring or attempt to run the operator without consulting the wiring diagram. We recommend that you install an optional reversing edge BEFORE proceeding with the control station installation. · ALL power wiring should be on a dedicated circuit and well protected. The location of the power disconnect should be visible and clearly labeled. · ALL power and control wiring MUST be run in separate conduit. · ALL electrical connections MUST be made using liquid tight fittings. IMPORTANT NOTE: For best protection against the environment follow directions below for required specifications for power and control wiring connections. ATTACHMENT TO ENCLOSURE 1. Select proper fitting entry hole to be placed in enclosure and punch through using drill or tool. Slide threaded body into fitting hole in enclosure, 3. [. . . ] Square off ends of conduit by cutting the end of the conduit squarely using a hacksaw or similar tool, conduit manufacturers sometimes offer cutting jigs for this purpose. Insert conduit flush with the fitting end stop. A compression gland nut, when provided as part of a fitting, will typically achieve maximum securement. [. . . ]