User manual LIFT-MASTER ELLCDKT

[. . . ] [. . . ] 3 Install LCD onto the four mounting posts. 6 Plug the small harness into the J1 connector on the LCD board and into J500 connector on the main board. 7 Plug the large harness into the Gray connector on the LCD board and into J300 connector on the main board. 4 Route the wire harnesses as shown, running them beneath the input and output boards. 5 Slip the larger harness into the two wire retainers. Gray Connector Small Wire Harness J1 Connector Wire Retainer 8 Pop black lens out of clear lens and discard. IO Output Board EXIT REQ 4 COM J7 NO J5 NC LED 4 Large Wire Harness DOOR STAT 4 EXIT REQ 3 COM DOOR STAT 3 EXIT REQ 2 COM DOOR STAT 4 EXIT REQ 1 COM DOOR STAT 1 J4 J5 J6 C RELAY 4 NO J4 NC C LED 3 RES POSTAL J3 J6 RELAY 3 NO AUTO J2 TELCO J1 POWER 12VAC/DC J3 NC C LED 2 NO RELAY 2 NC IO Input Board J8 J1 C LED 1 RELAY 1 D153 D102 Wire Retainer J500 H2 100A UD J406 LCD J405 J201 MIC D300 H2 100A UD J403 J401 3D2 100 16B D2 3D2 100 16B 3D2 100 16B H2 100A UD 9 Close and lock the unit. Connect power. J404 J301 3D2 100 16B J400 J300 BT300 SW300 OV UV J300 Connector D513 D514 J402 LEDJ200 SPKR 114A3265 3D2 100 16B + J407 DEVICE 3, 4 DEVICE 1, 2 J500 Connector © 2006, The Chamberlain Group, Inc. [. . . ] [. . . ]