User manual LIFT-MASTER MG1300

[. . . ] Wiring and Specifications for the MG 1300 Wiring Instructions Do Not Use Wire Smaller than 22 AWG Black ­ Black Green Anti-Tamper Plugs Anti-Tamper Plugs + White Red White Hardware List and Specifications Junction Plate Cover Screws (4) Junction Box Cover Magnetic Lock Plate and Junction Box Transformer Armature Side Screw Magnetic Lock Magnetic Lock Screws (4) Armature Plate Rubber Washer Housing: Junction Box: Magnet Plate: Plating: Power Supply: Transformer: Stainless Steel Steel Steel Zinc Clear 12 VDC Supply Input: 120 Vac, Output: 9. 6 VA 12 VDC @ 800mA Washers Guide Pins (2) Armature Armature Screw ® TM Mounting the MG 1300 Magnetic Lock HANDLING: The Magnetic Lock, Junction Box and Magnet Plate are ruggedly constructed and designed to provide years of trouble-free service. [. . . ] Again, Do not fully weld or you will burn the rubber pieces. 3 Remove the Armature Plate with Rubber Washer and Magnetic Lock from the Junction Box and fully weld the plates. 4 After it cools-off, reassemble Magnetic Lock and Armature with the Rubber Washer. Welding Anti-Tamper Plug Guide Pins Welding Magnetic Lock Mounting Screws Armature Allen Screw Magnetic Lock POST Magnetic Lock Plate Rubber Washer Washers Anti-Tamper Plug Armature Armature Plate Junction Box It is necessary to separate the MG 1300 parts from the Armature and Magnet Plates prior to welding. Failure to so will cause the wiring and rubber pieces to burn and melt. ® 01-50688B © 2005 The Chamberlain Group, Inc. [. . . ] All Rights Reserved For Technical Support: 1-800-528-2806 TM 845 Larch Avenue Elmhurst, Illinois 60126 www. chamberlain. com GATE Armature Screw [. . . ]