User manual LIFT-MASTER STAR250

[. . . ] Jumper J2 must remain in the default position unless otherwise noted. THERE ARE NO OTHER SERVICEABLE PARTS. TABLE OF CONTENTS DESCRIPTION PAGE Mounting Instructions for STAR250 . . 4 To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door: · ALWAYS keep remote controls out of reach of children. [. . . ] Hardware used will depend on on mounting application. (Refer to figure 1 for Receiver mounting hole locations). Direct Antenna Mounting: Install the supplied antenna onto the STAR250 antenna connector by screwing the connector clockwise. Slide the seal boot down to meet the O-Ring, covering the antenna hardware. Remote Antenna Mounting: Use the optional 86LM antenna extension kit to mount the remote antenna as high and far from metal as possible for best radio range (Figure 2). Contact LiftMaster customer service at: 1-800-528-2806 to order the model 86LM. Figure 1 Antenna Seal Boot Antenna Connector Figure 2 STAR250 FEATURES PROGRAMMING THE STAR250 Rapid LearnTM- Add transmitter to next available location. Adding Transmitter- Add transmitter to a specific location. Deleting a Transmitter- To delete a user. 2 PROGRAMMING THE STAR250 (CON'T) Blocking (Unblocking) a Transmitter- To block or unblock a user. Duplicating Memory- Allows user to back up learned transmitter memory into the provided backup memory module. dup , PRESS SIMULTANEOUSLY Main Memory Module END * 6 ~6 SECONDS Backup Memory Module NOTE: To duplicate memory, plug memory module into back up slot and press *, 6. Once duplication is complete, remove the backup memory module and store in a separate location. Restoring Memory- To restore memory, simply place the duplicate memory module from the backup memory location in the main memory position. For advanced functions, press and hold the (*) key and a number key at the same time to select the corresponding advanced function. (See table at right for available functions. ) Press the `#' key to exit the function. AUDIBLE DIAGNOSTICS Step 1. (LED will be displayed when OFF) Double Beep- Transmitter is valid & learned into STAR250accompanied by transmitter location display. Slow Beep- Security+ Transmitter (Not learned in STAR250). Fast Beep- Billion Code Transmitter (Not learned in STAR250). Triple Beep- Confirmation of Delete. KEYPAD SOUND ALERTS Single Beep- Key Pressed. Double Beep- Confirmation of an accepted Tx or valid Add/Block input. Long Beep- Blocked Tx, Error, or Out of Range TRANSMITTER LOCATION QUERY Step 1. Enter a transmitter location number (001-250) to view location status (See table to the right for possible status 3 TROUBLESHOOTING GUIDE Problem No display Probable Cause(s) 1. [. . . ] Transmitter battery is dead Transmitter won't learn 1. Transmitter may not be a recognized into memory Chamberlain transmitter Or 3. Transmitter battery is dead Unit does not function, Main memory module missing or [E 1] displayed damaged Duplication function does not work, [E 2] displayed Keypad does not respond, [E 3] displayed Backup memory module missing or damaged - If included Keypad has a stuck key Cycle power. [. . . ]