User manual LINKSYS BEFSR81

[. . . ] Instant Broadband® Series EtherFast® Cable/DSL Router with QoS and 8-Port Switch Use this guide to install: BEFSR81 ver. 2 User Guide COPYRIGHT & TRADEMARKS Copyright © 2003 Linksys, All Rights Reserved. Instant Broadband and EtherFast are a registered trademarks of Linksys. Microsoft, Windows, and the Windows logo are registered trademarks of Microsoft Corporation. [. . . ] Right-click the Local Area Connection that is associated with the Ethernet adapter you are using, and select the Properties option. In the This connection uses the following items box, highlight Internet Protocol (TCP/IP). Enter a unique IP address that is not used by any other computer on the network connected to the Router. You can only use an IP address in the ranges 192. 168. 1. 2 to 192. 168. 1. 99 and 192. 168. 1. 151 to 192. 168. 1. 254. Enter the Default Gateway, 192. 168. 1. 1 (Router's default IP address). Toward the bottom of the window, select Use the following DNS server addresses, and enter the Preferred DNS server IP Address and Alternative DNS server IP Address. Contact your ISP to find this information. Click the OK button in the Internet Protocol (TCP/IP) Properties window. Click the OK button in the Local Area Connection Properties window. My Internet connection isn't working. For Windows 95, 98, and Me: Refer to "Appendix D: Installing the TCP/IP Protocol" and "Chapter 4: Configure the PCs" for details. Make sure Obtain IP address automatically is selected in the settings. EtherFast® Cable/DSL Router with QoS and 8-Port Switch For Windows 2000: 1) Click Start, choose Settings, and open the Control Panel. Double-click Network and Dial-Up Connections. 2) Right-click the Local Area Connection that is associated with the Ethernet adapter you are using, and select the Properties option. 3) In the Components checked are used by this connection box, highlight Internet Protocol (TCP/IP), and click the Properties button. Make sure that Obtain an IP address automatically and Obtain DNS server address automatically are selected. 4) Click the OK button in the Internet Protocol (TCP/IP) Properties window, and click the OK button in the Local Area Connection Properties window. For Windows XP: The following instructions assume you are running Windows XP with the default interface. If you are using the Classic interface (where the icons and menus look like previous Windows versions), please follow the instructions for Windows 2000. 1) Click Start and open the Control Panel. 2) Click the Network and Internet Connections icon and then the Network Connections icon. 3) Right-click the Local Area Connection that is associated with the Ethernet adapter you are using, and select the Properties option. [. . . ] In the command prompt, enter ipconfig /all press the Enter key. Your PC's information will be displayed as shown in Figure F-5. EtherFast® Cable/DSL Router with QoS and 8-Port Switch Enter the 12-digit MAC address that you wrote down from the Physical Address shown in Figure F-5. Make sure to type the 12 digits without the hyphens into one of the fields for MAC Filtering. (See Figure F-6. ) Click on Apply when finished. Figure F-6 When entering information for MAC Address Cloning, type the 12-digit MAC address (see Figure F-7). [. . . ]