User manual LINKSYS LNE100TX

[. . . ] Instant EtherFast® Series EtherFast 10/100 LAN Card ® Use this guide to install: LNE100TX ver. 5 User Guide COPYRIGHT & TRADEMARKS Copyright © 2001 Linksys, All Rights Reserved. EtherFast is a registered trademark of Linksys. Microsoft, Windows, and the Windows logo are registered trademarks of Microsoft Corporation. [. . . ] · You might not have inserted the PCI card correctly or securely into the appropriate slot of your computer. Check that the card is securely inserted into the appropriate slot. · Try inserting your card into an alternate PCI slot. · You may have previously aborted a new hardware setup. Follow the directions in the Starting Over in Windows 95, 98 or 2000 section in the Appendix. · The motherboard in your system might not be Plug-and-Play compatible, your PC's Plug-and-Play settings may not be enabled, or the motherboard may have Plug-and-Play options not supported by Windows 95/98. If you are not sure, contact your PC's manufacturer. Windows can't locate the driver for the EtherFast Card device. · You may have inserted the wrong diskette into your PC's drive. · The diskette may be defective or files may be missing. Make sure the disk has a few files in a:\ starting with lne100 or a folder called Win95 for Window 95, Win98 for Windows 98, WinME for Windows Millennium, or Win2000 for Windows 2000. The Windows Logon screen doesn't appear after you restart your computer. · Click on Start, Shut Down, then Close All Programs and Logon as a Different User, (in Windows 98 or Millennium, select Log Off). If this doesn't solve the problem, your PC's manufacturer may have disabled Windows' networking. Contact your computer's manufacturer for help. After entering a username and password, a window appears that reads, "No Domain Server could be found to validate your Username and Password. " · Click on Start, Settings, Control Panel. Under The Following Network Components are Installed box, highlight Client for Microsoft Networks and click on the Properties button. Once you are in the Client For Microsoft Networks Properties window, make sure that Log on to Windows NT Domain is unchecked. Once you have made sure that it is unchecked click on the OK button and restart your computer. 49 5. On the Access Control Tab, User Level Access is selected, but Shared Level Access is grayed out and not accessible. · You previously had your primary network logon set to Client for NetWare Networks. On the Configuration tab of the Network Properties window, ensure that your primary network logon is set to Client for Microsoft Networks. [. . . ] Storage - The semi-permanent or permanent holding place for digital data. STP (Shielded Twisted Pair) - Telephone wire that is wrapped in a metal sheath to eliminate external interference. TCP/IP - Transmission Control Protocol/Internet Protocol (TCP/IP) is the basic communication language or protocol of the Internet. It can also be used as a communications protocol in a private network (either an intranet or an extranet). [. . . ]