User manual LINKSYS PC22224

[. . . ] ProConnect® II Series 2224 Layer 2 Management 24-Port 10/100 Ethernet Switch Use this guide to install: PC22224 User Guide COPYRIGHT & TRADEMARKS Copyright © 2002 Linksys, All Rights Reserved. EtherFast is a registered trademark of Linksys. Microsoft, Windows, and the Windows logo are registered trademarks of Microsoft Corporation. All other trademarks and brand names are the property of their respective proprietors. [. . . ] Since there is no precautionary message that appears before you delete a Routing Table entry, be sure you want to delete the entry before you begin. In this screen, the following details are displayed: 1. From the Routing Table screen, use the Up Arrow or Down Arrow key to highlight the Routing table entry you want to delete. Press the "-" (hyphen) key to delete the entry. To delete additional Routing Table entries, repeat steps 1 and 2. When you finish, press Esc to return to the Routing Table screen. Hops shows the IDs of the VLANs that have been defined. shows the corresponding IP addresses of the VLANs. shows whether the DHCP relay is enabled or disabled. shows the maximum number of hops that a DHCP request broadcast can be relayed along the DHCP relay path from the DHCP client to the DHCP server. 55 54 ProConnect II® Series Delay shows the number of seconds that must elapse before a DHCP request broadcast is relayed to the next IP subnetwork. shows any preferred servers that have been defined. shows the outbound IP subnetwork for relaying a DHCP request broadcast. 2224 Layer 2 Management 24-Port 10/100 Ethernet Switchnnect II 2224 Servers Relays The following procedure describes how to change the DHCP gateway settings. As part of this procedure, you can specify up to three preferred servers and/or an outbound relay interface. Highlight the appropriate VLAN ID and press Enter. A screen similar to the following will appear. 4. With the highlight on DHCP Gateway, press Enter. Highlight Enabled and press Enter to enable the DHCP gateway. Press the Down Arrow key and press Enter to configure the maximumnumber of hops. When the following screen appears, type the desired number and press Enter. 2. To add a relay IP, hold down the Shift key and press the "+" key. A screen similar to the following will appear. Highlight the appropriate interface, or highlight All Interfaces, then press Esc. [. . . ] Single-mode fiber cabling is somewhat more efficient than multi-mode but far more expensive, due to its smaller optic core that helps retain the intensity of traveling light signals. A fiber connection always require two fiber cables: one transmits data, and the other receives it. Each fiber optic cable is tipped with a connector that fits into a fiber port on a network adapter, hub, or switch. S. , most cables use a square SC connector that slides and locks into place when plugged into a port or connected to another cable. [. . . ]