User manual LINKSYS PC22604

[. . . ] ProConnect® II Series Layer 2 Management 4-Port Gigabit Ethernet Switch Use this guide to install: PC22604 User Guide COPYRIGHT & TRADEMARKS Copyright © 2002 Linksys, All Rights Reserved. EtherFast is a registered trademark of Linksys. Microsoft, Windows, and the Windows logo are registered trademarks of Microsoft Corporation. All other trademarks and brand names are the property of their respective proprietors. [. . . ] The address consists of numbers separated by periods (e. g. , 129. 32. 0. 11). The IP address you typed will appear next to Trap Host 1 IP Address. Type a set community name and press Enter. The set community name you typed will appear next to Set Community Name. Use the Down Arrow key to move to Trap Community Name and press Enter. The Enter Trap Community Name screen will appear. To specify up to two additional trap community names, repeat steps 10 through 12. To change the cold start trap setting, press the Down Arrow key to move to Cold Start Trap and press Enter. The Trap Options screen will appear. 8. Type a trap community name and press Enter. The set community name you typed will appear next to Trap Community Name. To specify up to three additional trap community names, repeat steps 7 and 8. To specify a trap host IP address, use the Down Arrow key to move to Trap Host 1 IP Address and press Enter. The Enter Trap Host 1 IP Address screen will appear (see next page). 15. Select Disabled or Enabled and press Enter. Your selection will appear next to Cold Start Trap. Press the Down Arrow key to move to Warm Start Trap and press the Enter key. The Trap Options screen will appear. 70 71 ProConnect II® Series 17. Select Disabled or Enabled and press Enter. Your selection will appear next to Warm Start Trap. Press the Down Arrow key to move to Link Down Trap and press the Enter key. The Trap Options screen will appear. Layer 2 Management 4-Port Gigabit Ethernet Switch Stacking Basic Setting enables you to set stack ID, stack size, and stack port. [. . . ] Most large networks contain several levels of interconnection, the most important of which include edge connections, backbone connections, and wide-area connections. UDP (User Datagram Protocol) - A method (protocol) used along with the IP (Internet Protocol) to send data in the form of message units (datagram) between network devices over a LAN or WAN. While IP takes care of handling the actual delivery of the data (routing), UDP takes care of keeping track of the individual units of data (called packets) that a message is divided into for efficient delivery over the network. UDP is known as a "connectionless" protocol due to NOT requiring the receiver of a packet to return an acknowledgment of receipt to the sender of the packet (as opposed to TCP). Layer 2 Management 4-Port Gigabit Ethernet Switch Upgrade - To replace existing software or firmware with a newer version. [. . . ]