User manual LINKSYS PCMLM56

[. . . ] EtherFast Series EtherFast 10/100 + 56K Modem PC Card User Guide COPYRIGHT & TRADEMARKS Copyright © 1999 Linksys, All Rights Reserved. Instant EtherFast is a registered trademark of Linksys. Microsoft, Windows, and the Windows logo are registered trademarks of Microsoft Corporation. All other trademarks and brand names are the property of their respective proprietors. [. . . ] When asked to choose the network services to install, do so. Click Next when you are finished. Click Next to install the components you have selected. Click Next. 42 Windows NT 5. Setup may need to copy some Windows NT files from your original Windows NT CD-ROM. If this window appears type in the location of your Windows NT CD-ROM. For example, if your CD-ROM is designated as D:, then type d:\i386. Setup may also need drivers from the Linksys diskette. NT will display the same windows as step 5 above. Type a:\ or the location of the floppy disk if this window appears. NT will ask you to supply the I/O Port, Interrupt, and Connection Type values for the card. 43 Windows NT Choose AutoSense for the Connection Type. Good values to start with for the other settings are 0x300 and 0x320 (for the I/O Port) and Auto (for the IRQ). Also choose the COM Port and IRQ that the modem will use. Do not enter settings that are being used by another device. If you're not sure of the interrupt and other resource values that are available for use on your PC, click on Start, then Run. Look at the IRQs that are already in use and choose one that is unused. To check the I/O values, click on the I/O Port button. When you're finished entering your I/O and Interrupt values, click on Continue. NT will copy necessary workstation files to your computer. If you have installed the TCP/IP protocol, the Setup will ask you if you will be obtaining IP addresses from a DHCP server. If you click Yes, continue on to step number 10. If you click No, you will need to obtain the necessary TCP/IP information from your Network Administrator to complete the TCP/IP properties requirements. When the Network Setup Wizard reappears, configure your bindings. See your Windows NT User Guide for more information on bindings. When the bindings are configured, click Next, followed by Next again to start the network. [. . . ] If you have a Dial-Up or AOL adapter installed, remove the IPX-SPXCompatible protocol for Dial-Up or AOL NetBEUI Click on the Add button. Under Network Protocol, highlight NetBEUI. If you have a Dial-Up adapter installed, remove the NetBEUI for Dial-Up Adpater protocol. If you were referred to this section by the Windows setup instructions, please return to step 16 of the setup now and continue following the instructions. [. . . ]