User manual LINKSYS SPA2100 PRODUCT BROCHURE

[. . . ] (Contact your ISP for more information. ) Enable MAC Clone Service. If your service uses a specific PC MAC address, then select yes from the E 1 A B Package Contents Phone Adapter with Router 5 V Power Adapter RJ-45 Ethernet Cable RJ-11 Phone Cable (not included with all models) · Power Adapter · Quick Installation · · · · Connect the Phone Adapter F Power off your network devices, including your modem and PC. Connect one end of an RJ-11 phone cable to the Phone Adapter's PHONE 1 port. Connect the other end to your analog telephone or fax machine. E MAC Clone Settings G Enable MAC Clone Service B H G D NOTE: Make sure your PC's Ethernet adapter is set to obtain an IP address automatically. [. . . ] 2 Enter the user name in the PPPoE Login Name field, and enter the password in the PPPoE Login Password field. If the Phone Adapter is preconfigured by your ITSP then you , do not need to change any of the default voice settings. Refer to the documentation supplied by your service provider for more information. If you want to change the settings for your Internet phone service, refer to the User Guide, which is available on the Linksys website at www. linksys. com. If you want to configure network settings using the Interactive Voice Response Menu, refer to the next section. This section explains how to use the Interactive Voice Response Menu to configure the Phone Adapter's network settings. You will use the telephone's keypad to enter your commands and select choices, and the Phone Adapter will use voice responses. To access the Interactive Voice Response Menu: The settings you have saved will take effect after you hang up the telephone. The Phone Adapter may reboot at this time. Action Interactive Voice Response Menu Command 111 Interactive Voice Response Menu Action Factory Reset Choices Description First, set the Internet Connection Type to static IP address; otherwise, you will hear, "Invalid Option, " if you try to set the static IP address. Use the * (star) key when entering a decimal point. First, set the Internet Connection Type to static IP address; otherwise, you will hear, "Invalid Option, " if you try to set the network or subnet mask. Enable/Disable WAN Access to the Web-based Utility 7932 Enable Press 1. Disable Press 0. A PPPoE B C D Use a telephone connected to the PHONE port of the Phone Adapter. (You can only access the Interactive Voice Response Menu through an analog telephone, not any of the Internet phones. ) Press **** (in other words, press the star key four times). Wait until you hear the "Linksys configuration menu--please enter the option followed by the # (pound) key or hang up to exit" response. Refer to the following table that lists actions, commands, menu choices, and descriptions. After you select an option, press the # (pound) key. To exit the menu, hang up the telephone. Set Network (or Subnet) Mask 121 User Factory Reset 877778 Check Internet Connection Type Check Internet IP Address 100 110 Set Gateway IP Address 131 Confirm Press 1. Cancel - Press * (star). Check Network Mask (or Subnet Mask) Check Gateway IP Address Check MAC Address 120 Set Primary DNS Server IP Address 161 * Follow these instructions to enter the password. · · · · · · · · · A, B, C, a, b, or c -- press 2. All Other Characters -- press 0. Using the Interactive Voice Response Menu While entering a value, such as an IP address, you may exit without entering any changes. Press the * (star) key twice within half a second. [. . . ] Bridge/Switch Mode - Press 1. If the Phone Adapter acts as the router for your network, use the router/NAT mode. If your network already has a router, use the bridge/switch mode. Use this setting to enable or disable WAN access to the Web-based Utility. (This Utility lets you configure the Phone Adapter. ) After you hear, "Option successful, " hang up the phone. [. . . ]