User manual LINKSYS SRW208MP

[. . . ] 8-Port 10/100 Ethernet Switch WIRED with WebView User Guide Model No. SRW208/SRW208G/SRW208L/SRW208P/SRW208MP WebView Switches Copyright and Trademarks Specifications are subject to change without notice. Linksys is a registered trademark or trademark of Cisco Systems, Inc. Copyright © 2006 Cisco Systems, Inc. Other brands and product names are trademarks or registered trademarks of their respective holders. [. . . ] The default value is 10 seconds. Security Tab - Multiple Hosts The Multiple Hosts screen allows network managers to configure advanced port-based authentication settings for specific ports and VLANs. Displays the port number for which advanced port-based authentication is enabled. Chapter 5: Using the Web-based Utility for Configuration Security Tab - Multiple Hosts 59 WebView Switches Enable Multiple Hosts. When checked, indicates that multiple hosts are enabled. Multiple hosts must be enabled in order to either disable the ingress-filter, or to use port-lock security on the selected port. Defines the action to be applied to packets arriving in single-host mode, from a host whose MAC address is not the supplicant MAC address. The possible field values are: · Discard. Discards the packets and shuts down the port. The ports remains shut down until reactivated, or until the device is reset. When checked, indicates that traps are enabled for Multiple Hosts. Defines the time period by which traps are sent to the host. The Trap Frequency (1-1000000) field can be defined only if multiple hosts are disabled. If there is an asterisk (*), the port is either not linked or is down. The possible field values are: Number of Violations. Indicates the number of packets that arrived on the interface in single-host mode, from a host whose MAC address is not the supplicant MAC address. Figure 5-34: Security - Multiple Hosts Security Tab - Storm Control Port. Displays the port number for which storm control is enabled. Indicates whether broadcast packet types are forwarded on the specific interface. Specifies the Broadcast mode currently enabled on the device. The possible field values are: · Unknown Unicast, Multicast & Broadcast. Counts Unicast, Multicast, and Broadcast traffic. Counts Broadcast and Multicast traffic together. The maximum rate (packets per second) at which unknown packets are forwarded. [. . . ] The foregoing limitations will apply even if any warranty or remedy provided under this Agreement fails of its essential purpose. Some jurisdictions do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to You. Please direct all inquiries to: Linksys, P. O. Box 18558, Irvine, CA 92623. 124 Appendix F: Warranty Information WebView Switches Appendix G: Regulatory Information FCC Statement This product has been tested and complies with the specifications for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ]