User manual LINKSYS WAP4400N

[. . . ] USER GUIDE with Ports 4-portuter Wireless-N Access Point with Power Over Ethernet BUSINESS SERIES Model No. No. Wireless-N Access Point with Power Over Ethernet Copyright and Trademarks Specifications are subject to change without notice. Linksys is a registered trademark or trademark of Cisco Systems, Inc. Copyright © 2006 Cisco Systems, Inc. [. . . ] To enable the SNMP support feature, select Enabled. The default is Disabled. Chapter 6: Configuring the Wireless-N Access Point The Administration - Management Tab 28 Wireless-N Access Point with Power Over Ethernet This Access Point supports SNMP version 1, 2, and 3. Select SNMP V1 & V2 if you don't need the enhanced capability on V3 or your management software does not support V3. Otherwise, select SNMP V3. Identification Contact. Enter the name of the contact person, such as a network administrator, for the Access Point. Enter the name you wish to give to the Access Point. Create a administrator account to access and manage the SNMP MIB objects. Enter the authentication password for administrator account (minimum length 8). Enter the passphrase for data encryption on administrator's management traffic. Enter the password that allows read-only access to the Access Point's SNMP information. Enter the password that allows read/write access to the Access Point's SNMP information. Enter the password required by the remote host computer that will receive trap messages or notices sent by the Access Point. You can restrict access to the Access Point's SNMP information by IP address. Enter the IP address in the field provided. If this field is left blank, then access is permitted from any IP address. Enter the IP address of the remote host computer that will receive the trap messages. Change these settings as described here and click Save Settings to apply your changes, or click Cancel Changes to cancel your changes. Help information is displayed on the right-hand side of the screen, and click More for additional details. Chapter 6: Configuring the Wireless-N Access Point The Administration - Management Tab 29 Wireless-N Access Point with Power Over Ethernet The Administration - Log Tab On this screen you can configure the log settings and alerts of particular events. Log You can have logs that keep track of the Access Point's activities. Email Alert E-Mail Alert. If you want the Access Point to send e-mail alerts in the event of certain attacks, select Enabled. Enter the e-mail address that will receive logs. Figure 6-19: The Administration - Log Notification Queue Length Log Queue Length. You can designate the length of the log that will be e-mailed to you. [. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used according to the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which is found by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna · Increase the separation between the equipment or devices · Connect the equipment to an outlet other than the receiver's · Consult a dealer or an experienced radio/TV technician for assistance FCC Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. [. . . ]