User manual LINKSYS WIRELESS-G USB NETWORK ADAPTER WITH SPEEDBOOSTER QUICK INSTALLATION

[. . . ] ® 1 Begin Installation IMPORTANT: Do not connect the Adapter to Your PC until you are instructed to do so in Step 2 or the Adapter will not install propertly. 2 Connect the Adapter A Division of Cisco Systems, Inc. Now that the Setup Wizard has prompted you to connect the Adapter, follow the instructions below. The USB Network Adapter is installed and set up using the Setup Wizard that comes on the CD enclosed. A B C A D Connect one end of the included USB cable to the Adapter's USB port Connect the other end of the cable to one of the USB ports on your computer. The Power LED should light up when the Adapter is plugged in. Make sure the antenna points straight up into the air, at a 90º angle from the Adapter. [. . . ] Valid hexadecimal characters are "0" to "9" and "A" to "F". Then, click Connect and proceed to Step B. PSK Needed for Connection Encryption - Select the type of algorithm you want to use, TKIP or AES, from the Encryption dropdown menu. Passphrase - Enter a Passphrase of 8-63 characters in the Passphrase field. The longer and more complex your Passphrase is, the more secure your network will be. Then, click Connect and proceed to Step B. The next screen to appear will be the Available Wireless Network screen. From this screen, you can launch one of the three setup methods. A Available Wireless Network IMPORTANT:There are three ways to set up the Adapter. For Quick Installation, use this document only if your network appears on the Available Wireless Network screen. SecureEasySetup: If you are utilitizing SecureEasySetup, click the SecureEasySetup button and follow the on screen prompts. Manual Setup: If you are utilitizing Manual Setup, click the Manual Setup button and follow the on screen prompts. If wireless security has been enabled on this network, you will see a wireless security screen. If your network utilizes WEP (Wired Equivalent Privacy) encryption, the WEP Key Needed for Connection screen will appear. If your network utilizes PSK (Pre-Shared Key) encryption, the PSK Key Needed for Connection screen will appear. WEP Key Needed for Connection Select 64-bit or 128-bit. Passphrase - Enter a passphrase in the Passphrase field. This is case-sensitive and should not be longer than 16 alphanumeric characters. It must match the passphrase of your other wireless network devices and is compatible with Linksys wireless products only. (Non-Linksys wireless products, require a WEP key to be entered. ) WEP Key - The WEP key must match the WEP key of your wireless network. [. . . ] Double-click the icon if you want to open the Wireless Network Monitor for finding available wireless networks or making additional configuration changes. Wireless Network Monitor icon Linksys is a registered trademark or trademark of Cisco Systems, Inc. Copyright © 2005 Cisco Systems, Inc. All rights reserved. wusb54gs-qi-50418A BW Model No. [. . . ]