User manual LINKSYS WMP54GX

[. . . ] ® A Division of Cisco Systems, Inc. 2. 4 GHz Wireless-G 802. 11g PCI Adapter with SRX WIRELESS Model No. User Guide WMP54GX Wireless-G PCI Adapter with SRX Copyright and Trademarks Specifications are subject to change without notice. Linksys is a registered trademark or trademark of Cisco Systems, Inc. Copyright © 2005 Cisco Systems, Inc. Other brands and product names are trademarks or registered trademarks of their respective holders. [. . . ] Then, click Connect and proceed to the Congratulations screen. Figure 5-16: WPA-Personal Needed for Connection WPA2 - Personal Needed for Connection AES is automatically used as the encryption method. Passphrase - Enter a Passphrase, also called a pre-shared key, of 8-63 characters in the Passphrase field. The longer and more complex your Passphrase is, the more secure your network will be. Then, click Connect and proceed to the Congratulations screen. Figure 5-17: WPA2-Personal Needed for Connection 2. After the Adapter has been configured for the network, the Congratulations screen will appear. Click Connect to Network to connect to your network. Congratulations!The profile is complete. Figure 5-18: Congratulations Screen Chapter 5: Using the Wireless Network Monitor Creating a New Profile 26 Wireless-G PCI Adapter with SRX Setting Up the Adapter with Manual Setup Click Manual Setup on the Available Wireless Network screen to set up the Adapter manually. 1. After clicking Manual Setup, the Network Settings screen will appear. If your network has a router or other DHCP server, click the radio button next to Obtain network settings automatically (DHCP). If your network does not have a DHCP server, click the radio button next to Specify network settings. Enter an IP Address, Subnet Mask, Default Gateway, and DNS addresses appropriate for your network. You must specify the IP Address and Subnet Mask on this screen. If you are unsure about the Default Gateway and DNS addresses, leave these fields empty. IP Address - This IP Address must be unique to your network. Subnet Mask - The Adapter's Subnet Mask must be the same as your wired network's Subnet Mask. Default Gateway - Enter the IP address of your network's Gateway here. DNS 1 and DNS 2 - Enter the DNS address of your wired Ethernet network here. Figure 5-19: Available Wireless Network Screen Click Next to continue, or click Back to return to the Available Wireless Network screen. Figure 5-20: Network Settings Screen Chapter 5: Using the Wireless Network Monitor Creating a New Profile 27 Wireless-G PCI Adapter with SRX 2. The Wireless Mode screen shows a choice of two wireless modes. Click the Infrastructure Mode radio button if you want to connect to a wireless router or access point. Click the Ad-Hoc Mode radio button if you want to connect to another wireless device directly without using a wireless router or access point. Then, enter the SSID for your network. Infrastructure Mode - Use this mode if you want to connect to a wireless router or access point. [. . . ] EN 609 50 Safety Appendix H: Regulatory Information 51 Wireless-G PCI Adapter with SRX EN 300-328-1, EN 300-328-2 Technical requirements for Radio equipment. Caution: This equipment is intended to be used in all EU and EFTA countries. Outdoor use may be restricted to certain frequencies and/or may require a license for operation. Contact local Authority for procedure to follow. [. . . ]