User manual LINKSYS WPC11

[. . . ] Instant WirelessTM Series Network PC Card & PCI Adapter Use this Guide to install the following: WPC11 & WDT11 User Guide COPYRIGHT & TRADEMARKS Copyright © 2001 Linksys, All Rights Reserved. Instant WirelessTM is a registered trademark of Linksys. Microsoft, Windows, and the Windows logo are registered trademarks of Microsoft Corporation. All other trademarks and brand names are the property of their respective proprietors. [. . . ] Click the Finish button to continue and then restart your computer. Once your computer has restarted, you can continue on to the Configuration Utility section. 2. To add the Network PC Card, you will want to click the Adapters tab and then click the Add button to continue. NOTE: After you have installed the Network PC Card, reapply the Windows NT service pack. 43 44 Instant WirelessTM Series 3. A list of adapters will appear on the next screen. You will not want to select one of these, however, as your installation disk (Setup Utility CD) has all of the appropriate drivers. Click the Have Disk button to continue. Network PC Card and PCI Adapter 6. You will now reach the Resources & Properties screen. Check with your wireless settings for the information you need. For more information concerning these settings, refer to the section Configuring the Network PC Card for Windows NT. Adjust the settings as are appropriate and click the OK button. 4. On the Insert Disk screen, type "D:\WPC11-WDT11\WINNT" (where D: is the letter of your CD-ROM drive) in the field provided. Then, click the OK button to continue. 5. The Select OEM Option screen will show two options from which to choose. You will want to highlight Instant Wireless - Network PC Card and click the OK button to continue. 7. The Network PC Card has now been installed. Click the Close button to continue and then restart your computer. Continue on to the Configuration Utility section to configure your wireless connection. NOTE: After you have installed the Network PC Card, reapply the Windows NT service pack. 45 46 Instant WirelessTM Series Setting up the Network PC Card for Windows 2000 1. Windows 2000 will automatically identify the Network PC Card, once it is connected to the PC, and prompt you to install the necessary driver. Make sure that Setup Utility CD is inserted into your CD-ROM drive and click the Next button on the Found New Hardware Wizard screen to proceed. Network PC Card and PCI Adapter 3. Select Specify a location, click the Next button, then type in "D:\WPC11WDT11\win2000" (where D: is the letter of your CD-ROM drive) and click the Next button. Type in d:\WPC11-WDT11\win2000 (where "D" is the letter of your CD-ROM drive) in the Copy manufacturer's files from field and click the OK button. 2. This will search for the Windows 2000 driver. 4. [. . . ] Properly synchronized, the net effect is to maintain a single logical channel. To an unintended receiver, FHSS appears to be short-duration impulse noise. Direct-Sequence Spread-Spectrum (DSSS) generates a redundant bit pattern for each bit to be transmitted. This bit pattern is called a chip (or chipping code). [. . . ]