User manual LINKSYS WRT120N

[. . . ] While reading through the User Guide you may see various icons that call attention to specific items. Below is a description of these icons: NOTE: This check mark indicates that there is a note of interest and is something that you should pay special attention to while using the product. WARNING: This exclamation point indicates that there is a caution or warning and it is something that could damage your property or product. Website addresses in this document are listed without http:// in front of the address because most current web browsers do not require it. [. . . ] View Log To view the logs, click View Log. IP or URL Address Enter the address of the computer whose connection you wish to test. Number to Ping Enter the number of times you wish to test the connection. Start to Ping To run the test, click this button. NOTE: Do not restore the factory defaults unless you are having difficulties with the Router and have exhausted all other troubleshooting measures. Once the Router is reset, you will have to re-enter all of your configuration settings. Restore All Settings To reset the Router's settings to the defaults, click this button and then follow the on-screen instructions. Any custom settings you have saved will be lost when the default settings are restored. Do not upgrade the firmware unless you are experiencing problems with the Router or the new firmware has a feature you want to use. IP or URL Address Enter the address of the computer whose connection you wish to test. Start to Traceroute To run the test, click this button. NOTE: The Router may lose the settings you have customized. Before you upgrade its firmware, write down all of your custom settings. After you upgrade its firmware, you may have to re-enter all of your configuration settings. Before upgrading the firmware, download the Router's firmware upgrade file from the Linksys website, www. Start to Upgrade After you have selected the appropriate file, click this button, and follow the on-screen instructions. WARNING: The firmware upgrade must not be interrupted; do not reboot or power off the Router during the firmware upgrade. This section shows the current network information stored in the Router. The Router screen displays information about the Router and its current settings. Router IP Address The Router's IP address, as it appears on your local network, is displayed. Internet MAC Address The Router's MAC Address, as seen by your ISP, is displayed. Start IP Address For the range of IP addresses that can be used by devices on your local network, the starting IP address is displayed. [. . . ] This Class B digital apparatus complies with Canadian ICES-003 and RSS210. Operation is subject to the following two conditions: 1. This device may not cause interference and 2. This device must accept any interference, including interference that may cause undesired operation of the device. [. . . ]