User manual LISTAESCAN FOLDING SHELF FOR CABINETS

[. . . ] INSTALLATION AND USE INSTRUCTIONS FOR THE CABINET FOLDING SHELF CAUTION MAXIMUM LOAD CAPACITY IS 50 LBS. [. . . ] (See Figure 4) 2 Align bottom holes in Shelf Struts with slots in Lower Struts . (See Figure 5) 3 Secure with Bracket Pin and insert Cotter Pin pletely through hole in Bracket Pin. com- Shelf Assembly with Shelf Struts pre-assembled 4 Secure Shelf Assembly to Mounting Brackets with Bracket Pins and insert Cotter Pins completely through hole in Bracket Pins . 5 Apply two rubber shelf Bumpers to the edge of the Shelf that faces the Cabinet Housing . (See Figure 6) Cabinet Housing with pre-drilled holes Page 2 Figure 1 Figure 2 Lower Strut Snap Leg VIEW A Assembling Lower Strut to Mounting Bracket Positioning Mounting Bracket Figure 3 #10 x ½" Screws Figure 4 Shelf Mount Bracket Pin Cotter Pin Shelf Assembly CAUTION: Insert Cotter Pin Completely Mounting Bracket Left Side Shown Shelf & Mounting Bracket Assembly Figure 5 Figure 6 Bumpers Strut Assembly Installing Bumpers Page 3 Folding the Shelf (See Figures 8 & 9) 1 Lift the Shelf up and with two hands grasping the upper struts at the same time, carefully collapse the Struts and lower until the Shelf engages into Snap Clip. CAUTION: BE SURE SHELF IS EMPTY BEFORE FOLDING AND KEEP FINGERS CLEARLY AWAY FROM ANY POSSIBLE PINCH POINTS (JOINT WHERE STRUTS FOLD AND IN BETWEEN SHELF AND CABINET HOUSING). Figure 8 Extending the Shelf (See Figure 10) 1 Grasp lower edge of Shelf and firmly pull away from Snap Clips. Shelf Extended Figure 9 Figure 10 Inspection Inspect completed Shelf Assembly by raising & lowering Shelf. Ensure that parts work properly without binding or scratching paint. Drilling Holes in Existing Cabinets (See Figure 11) Note: Lista cabinets ordered with Folding Shelves are pre-drilled for our customer's convenience. In order to install a folding Shelf onto an existing cabinet, you must drill 8 mounting holes into the cabinet. [. . . ] 235 or 233 E-mail: sales@listaintl. com Document Number: MD022A3, Rev 0, 05/2000 © 2000 Lista International, all rights reserved ISO 9001 Certified Page 4 SIDE VIEW Dimensions are noted in metric [inches] [. . . ]