User manual LISTAESCAN STORAGE WALL ROLLER SHELF INSTALLATION INSTRUCTIONS

[. . . ] Storage Wall® Roller Shelves Assembly Instructions and Layout Guide ! CAUTION ALWAYS SECURELY ANCHOR STORAGE WALL SYSTEMS TO THE FLOOR OR A SOLID OR REINFORCED WALL WHEN USING ROLLER SHELVES. FOLLOW LOCAL REGULATIONS AND BUILDING CODES TO DETERMINE THE PROPER METHOD OF ANCHORING. STORAGE WALL TM UNITS MUST BE LEVEL IN ALL DIRECTIONS. 770 POUND CAPACITY PER SHELF. [. . . ] · Once placement of all tracks is completed, insert the white plastic shelf retainer slip (#15) to secure tracks · Refer to Figure 1. Using four ¼-20 x 5/8" hex head bolts (#8), install the back panel (#3). You will need access to the rear of the storage wall. If access to the rear of the storage wall is not available, install the back panel backwards. · Slide the Storage Wall system in place and anchor units. · CAUTION: Units must be level in all directions and securely anchored to the floor according to local regulations and building codes. Note: The rollers supplied are standard conveyor rollers. One end of the center shaft is fixed, the other is spring loaded. It is easier to install the rollers from below the tracks. Fixed end goes into the left track (#1), spring loaded end goes into right track (#2). Depress spring loaded end with a medium flat head screw driver to slide shaft into the hole in the right shelf track. · Install left gate bracket (#5) by sliding it into the left track (#1) and align with the angled gate slot. Secure using one ¼-20 x 5/8" head head bolt · Grease or lubricate both ends of the Gate Pivot Rods (#4). · Place a flat washer (#9) on the left pivot rod of the gate and insert rod into the left gate bracket. [. . . ] Insert end cap back into the end of the handle. · Figure 1 ­ Exploded view Figure 2 ­ leave 5 (approx. 5") open slots between bottom panel & shelf track Component and Hardware List ITEM 1 2 3 4 5 6 7 DESCRIPTION QTY Shelf Track - left 1 Shelf Track - right 1 Backstop 1 Front gate* 1 Gate bracket ­ left 1 Gate bracket ­ right 1 Conveyor Rollers ­ 21-3/4" deep 7 ­ 27-3/4" deep 9 8 Hex head bolts ­ ¼-20 x 5/8 6 9 3/8" flat washer 2 10 Gate handle (aluminum)* 1 11 Gate handle label 1 12 Gate handle label plastic cover 1 13 End cap ­ left* 1 14 End cap ­ right* 1 15 Track retainer clip 2 * The front gate, including the aluminum handle and both end caps, will ship pre-assembled. Figure 3 ­ Install Conveyor Rollers Figure 4 ­ Completed Roller Shelf Layout Guide for Roller Shelves · · · · · · Bottom Shelf must be a minimum of 5" (125 mm) or 5 notches from bottom universal panel. Roller Shelves adjust in 1" (25 mm) increments Minimum clearance needed for each shelf is 4" (100 mm) Roller height: 2" (50 mm) Total usable height of 1450 unit Storage Wall section: 53" (1350 mm) Total usable height for 2000 unit Storage Wall section: 75" (1900 mm) Suggested Layout for a four shelf section GATE HEIGHT 4" [100mm] 106 Lowland St Holliston, MA 01746 E-mail: sales @ listaintl. com http://www. listaintl. com/ For Technical Asstance, please call 800-423-1350 MD007A3 Rev 1, 11/2001 ©2001 Lista International Corp. [. . . ]