User manual LISTAESCAN STORAGE WALL SAFETY LADDER INSTRUCTIONS

[. . . ] Do not fully tighten the Upper Track section at this time. Insert a bumper into one end of the Upper Track to prevent the T-Mast from rolling out. Place the T-Mast so that the grooved rollers glide over the rail on the Upper Track. (The T-Mast hangs on the Upper Track) Release the Hand Brake by pushing the handle down so that the ball-bearing rollers on the top run smoothly. [. . . ] Once the Bottom Track is level, securely tighten all M8 Hex Head bolts and nuts so that the bottom glides of the T-Mast are firmly in place. Installing the Safety Hooks Step 1 2 3 Action (Refer to Figure Chapter 3 -1) Install the Safety Hooks on the upper left and right ends of the T-Mast so that the hook is behind the Upper Track. Release the Hand Brake by pushing the brake handle down. Test the mobility of the T-Mast to ensure that it rolls freely and evenly across the entire length of the Storage Wall. Inspect and adjust the Bottom Track if necessary. Make sure all Hex Head bolts and nuts are securely tightened to prevent misalignment. 3 4 5 2 3 4 5 3-2 Figure Chapter 3 -1 Upper Track Components Figure Chapter 3 -2 Bottom Track Figure Chapter 3 -3 Bottom Track Joint 3-3 Attaching the Folding Steps to the T-Mast Lista completely assembles the Folding Steps at the factory. It is important to keep all the strapping material in place as it is received to ease handling during installation. Attaching the Folding Steps to the T-Mast Step 1 2 3 Action (Refer to Figure Chapter 3 -4 and Figure Chapter 3 -5) Using a 19mm Socket wrench, remove the two bolts from the Swivel Supports on the front of the T-Mast. Insert the Plated Shaft into the Swivel Cylinder (attached to the Folding Steps). Slide the Ladder (with the Plated Shaft in place) in between the Swivel Supports on the T-Mast. Insert the top and bottom 19mm Hex Head bolts through the Swivel Supports and into the Plated Shaft. Tighten securely using a 19mm Socket wrench. Attaching the Handle Step 1 2 3 4 Action Insert the spring-loaded Brake Handle above the Swivel Support using M8 x 10 Hex Head bolts. Tightly secure using a 13mm Socket wrench. Mount the Swivel-Control Handle using the roll-pin and C-clip retainer. With the Safety Ladder in the locked position (steps folded), cut the strapping material. With the brake engaged, push the Safety Ladder to the left and right. Push the Brake Handle down and ensure that the lower and upper brakes release. Note: The Handle locks the Safety Ladder in place. Push the Handle down to change positions. Operating the Safety Ladder The following table describes how to open and close your Safety Ladder. If you want to: Open the Steps (in either direction) Close the Steps Position the Ladder Left or Right Move the Ladder along the Storage Wall Then do this: Pull the black knob down to release the locking mechanism, then push the bottom step down. [. . . ] Slide the Ladder (wheels) onto the Ladder Tracks from either side. Adjust the safety hook and secure with an M10 Hex nut from behind the T-Mast. Attach the End Stops to the upper and lower tracks. Note: If necessary, adjust the brake pad so that the ladder flows easily along the track. Maintaining the Safety Ladder Perform the following steps periodically to maintain the Safety Ladder: · · · · · Make sure that both the Upper and Bottom Tracks are clean. There should be no dirt, rags, metal fillings, parts, or other debris in the track. [. . . ]