User manual LOC8TOR LOC8TOR LITE

[. . . ] It will beep and all the lights will flash ­ It is now ON. 45 seconds left idle your Loc8tor will turn itself off. Tag beeps twice and the red light flashes twice . ⷠPlace Tag you wish to register next to Loc8tor making sure all other Tags have been moved more than an arms length away. [. . . ] As you get closer amber then red lights illuminate and the audio pitch increases. FOUND To stop a search press ON/OFF button or the locate button your Tag is allocated to. Place the Tag on a surface and practice locating a few times to get a feel for how it works. ⷠIf you are ever unsure which direction to go in slowly repeat full 360° circle and then go in the direction with the strongest signal strength. Try moving Loc8tor up and down as the Tag could be upstairs or downstairs. ⷠIf you are close to a wall whilst getting a strong signal check the room next door. ⷠTry pressing the volume button on the Loc8tor when you are close in order to mute and listen out for Tag beeps. ⷠIf no signal is displayed try moving position to a different area and repeat process. RANGE GUIDELINES Range will vary greatly depending on where the Tag is used and what it's attached to. If higher up and with a clear line of sight, items can be found in excess of 122m/400feet. Actual range may differ significantly as performance is affected by type of application and environment it's used in. Model Aircraft up a tree Attach bracket to the fridge or any other metal surface using the sticky backed magnet or attach it to a door/wall using the raw plug and screw provided. Place the sticker on the inside of the mounting bracket as a quick reminder what you have tagged. BATTERIES Loc8tor Handheld: If the Loc8tor does not power up or lights are faint replace the battery using 1 x CR2032 or equivalent placing in the battery compartment + side up. Battery compartment can be found on the back at the bottom. To change the batteries in a Tag: Put your thumbnail or a flat tool at the end of the Tag, by the lanyard hole, into the split line (line going around the middle of the Tag). Keeping your thumbnail / flat tool in the split line move it around to the middle of the long side. 5v button cells or equivalent to provide best battery life, keeping the plus side face up nearest the lanyard hole. ⷠReplace the lid by putting one side in first then pushing shut. ⷠIf batteries are correctly inserted the Tag will beep when case is closed. To test batteries open then shut lid by following the above steps. UNREGISTER A TAG Once a Tag has been registered only that button can be used to locate it. [. . . ] Whilst reasonable efforts have been made in the preparation of these instructions to ensure its accuracy, Loc8tor Ltd. Assumes no liability resulting from errors or omissions in this User Guide, or from the use of the information contained herein. Reserves the right to make changes to the product design without reservation and without notification to its users. FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. [. . . ]