User manual LOGITECH E2500

[. . . ] 1a) Then, plug the network adapter into the power outlet. 2) Connect the other blue cable connector into an open port on your router. 3 Plug in Your Camera When prompted to connect your camera: 1) Remove the hatch from the back of the camera. 1a) Plug the yellow cable connector into the port. [. . . ] 1b) Use the lock slider to lock the connector in place. 2) Plug the yellow cable connector into the power supply port. 2a) Plug the power supply into an outlet near the PC where the software is installed. 1 1a 2 1) Insert the Software Install CD and follow the instructions during the install. · The installer will check for the latest version of the software. Alternatively, you can download the latest version at www. logitech. com/downloads. 3) Logitech Alert Commander software will open. 4) The First Run Wizard will guide you through the next steps of setup. See instructions in "Camera Reset Instructions. " HELP To lengthen, either use a coupler or purchase a longer ethernet (CAT-5e) cable. Insert a paper clip into the reset hole located on the back of the camera and press gently and then release. Logitech Alert Video Security System TM Refer to System Requirements Guide. Quick-start guide GETTING TO KNOW TM 0i Logitech Alert 700i/75 irements Quick-start guide System Requ & Support Guide Want to see more FAQs? Go to www. logitech. com/security/support If the camera does not appear after reset, go to Settings > Cameras > Add/Find > Find Cameras. If the camera still does not operate, contact technical support. Resetting the camera will restore the camera to factory settings. However, it will not delete video recorded on the microSD card. Reading the Diagnostic LEDs LED OFF ON Camera Diagnostic LED On/Off switch for Power Supply / Network Adapter LEDs Camera Diagnostic LED Power Supply / Network Adapter Diagnostic LEDs Power Supply Network Status LEDs (Top) Motion LED Which LED colors indicate "camera is working"? Connected to Internet (Green) Connected to Alert Commander (Purple) Connected to Alert Commander & Internet (Blue) Upgrading Firmware (White) Camera in standalone mode (Yellow) Not connected to Alert Commander or Internet (Light Blue) Which LED colors indicate "camera is not working"? Camera boot-up failed * (Red blinking) microSD card read/write failure - No microSD card * (Alternating Red / Yellow, blinking) How do I turn these LEDs off? Use the switch located on the side of the power supply or network adapter to disable these diagnostic LEDs. How do I know the camera is recording? Camera is ready to record (Red) Camera is recording (Red, blinking) What do these LEDs tell me? Traffic and data is flowing (Green) Connection with Ethernet/LAN (Yellow) What do these LEDs tell me? Link to Power Supply (Green) Shows network traffic (Blue) Turning Off Motion and Diagnostic LEDs You can turn off the motion and diagnostic LEDs in the Settings > Cameras > Camera > Show LED for. . . . See F1 Help for instructions. * See Camera Reset Instructions for assistance. Using the microSDTM card adapter NOTE: Unplug the camera before removing, replacing, or upgrading your microSD card. To review the video on the microSD card, we recommend you using Logitech Alert Commander. To review the video on the microSD card without Logitech Alert Commander: 1) Open the hatch on the bottom of the camera and remove the microSD card from its port. [. . . ] To review the video on the microSD card without Logitech Alert Commander: 1) Open the hatch on the bottom of the camera and remove the microSD card from its port. 2) Plug the microSD card into the adapter. SMA RTM 1 2 3 3) Plug the adapter into the PC's SD card slot. · View video recordings using the free Apple QuickTime player or other player that supports H. 264 video playback. [. . . ]