User manual LOGITECH WIRELESS MUSIC SYSTEM FOR PC

[. . . ] For home stereo / home theater systems Plug the other end into an `aux input' or `line-in' jack on your home stereo. Plug the power adapter into the Music Receiver. If you use your Wireless Music System without installing the software, all of your computer's sound will be redirected to the speakers that are connected to the Music Receiver. (This includes both your media player music as well as standard Windows® sound effects). [. . . ] Make sure the antennas on the Transmitter and the Receiver are extended. Use the desktop stand with the Transmitter. Plug the Transmitter (or desktop stand) directly into a USB port on your PC ­ do not use a USB hub. When using a desktop PC, plug the Transmitter into a USB port on the back of your PC. Make sure that the Transmitter and Receiver are each at least 6 feet away from other devices that emit radio waves (cordless phones, WiFi access points, microwave ovens, etc. I press play in my media player, but the music is still coming out of my PC speakers. Make sure to start your media player after plugging the Transmitter into your PC. If you are using the Logitech® Music AnywhereTM software, check the settings to make sure the playback location for your media player is set to the Logitech® Music AnywhereTM adapter. Use this setting when you are using a speaker system (such as a multimedia system) that doesn't have its own remote volume control. Put the switch in the `Fixed' position to force the Receiver to always output a full-strength, line-level signal. this will disable the volume buttons on the Receiver. Use this setting when you are using a home stereo system that has its own remote volume control. You may also check out our FAQ section at www. Si vous utilisez le support de bureau, assurez-vous que le câble USB du support est complètement enfoncé dans le port. Do not block any ventilation openings. Do not push objects into apparatus vents or slots because fire or electric shock hazards could result. Maintain a minimum distance of at least 6 inches around apparatus for sufficient ventilation. Ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table clothes, curtains, etc. No naked (open) flame sources, such as lighted candles, should be placed on or near the apparatus. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized plug. A polarized plug has two blades with one wider than the other. [. . . ] NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ]