User manual LORUS V657

[. . . ] S t o p w a t c h : Measures up to 60 minutes in 1/10 second increments. ·Split time measurement Stopwatch second hand 1. Press "A" repeatedly to reset the stopwatch 1/10-second hand to the "0" position. Press "B" repeatedly to reset the stopwatch second and minute hands to the "0" position. [. . . ] The watch is so designed that the date changes once in 24 hours. When setting the minute hand, first advance it 4 to 5 minutes ahead of the desired time and then turn it back to the exact minute. s HOW TO USE THE STOPWATCH · The stopwatch can measure up to 60 minutes in 1/10 second increments. · The measured time is indicated by the small stopwatch hands that move independently of the center hands. Stopwatch 1/10-second hand 6 s NECESSARY PROCEDURE AFTER BATTERY CHANGE · When the battery is replaced, the time information stored in the built-in IC and the time indicated by the stopwatch hands do not correspond with each other. Before using the watch, therefore, be sure to reset the hands to the "0" position, following the procedure below. * In case any of the hands should move improperly, follow the procedure below to adjust the hand movement. A Stopwatch minute hand Stopwatch 1/10-second hand B Stopwatch second hand A Crown Stopwatch minute hand 6 After the measurement exceeds 1 minute, the stopwatch 1/10-second hand stays at the "0" position. When the measurement is stopped, it will move to indicate the elapsed 1/10 seconds. B Second click Stopwatch operation Standard measurement Stopwatch second hand A Start A Stop B Reset Accumulated elapsed time measurement A Start A Stop A Restart A Stop B Reset * Restart and stop of stopwatch can be repeated by pressing button "A". Split time measurement 1. P r e s s a n d h o l d " A " a n d " B " a t t h e s a m e time for 2 seconds, and then release the buttons. * The stopwatch second hand turns half a circle counterclockwise and then returns where it was. The stopwatch 1/10-second hand turns a full circle clockwise and stops. Press "A" repeatedly to reset the stopwatch 1/10-second hand to the "0" position. Press "B" repeatedly to reset the stopwatch second and minute hands to the "0" position. * The hands move quickly if the respective buttons are kept pressed. Turn the crown to set the hour and minute hands to the desired time. * For details, refer to "HOW TO SET THE T IME/CALENDAR ") 5. Push the crown back into the normal position. A Start B Split B Split release A Stop B Reset s LUMIBRITE WATCH (dial, hands, buttons, case, bezel, strap, etc. ) * Measurement and release of split time can be repeated by pressing button "B". Note: When "B" is pressed to reset the stopwatch to "00", the stopwatch second and minute hands return to "0" position in 40 seconds. 6 If your watch is a LORUS LUMIBRITE watch, it has following features. LORUS LUMIBRITE watches absorb and store light energy from natural and artificial light sources and emit light in the dark. They are made of environmentally friendly material, and therefore, are harmless to human beings and the environment. · With a full charge, LORUS LUMIBRITE watches glow in the dark hours longer than conventional luminous watches of this type. If exposed to a light of more than 500 lux (i. e. , the brightness of a typical office) for approximately 10 minutes, or direct sunlight for 2 minutes, they will glow for hours. · Since LORUS LUMIBRITE watches emit the light they store, the brightness will decrease gradually over time. The length of time they will glow may also differ slightly depending on such factors as the brightness of and distance from the light source used to charge the watch. s BATTERY CHANGE The miniature battery SEIKO SR920SW, Maxell SR920SW, SONY SR920SW, Matsushita SR920SW or EVEREADY 371, which powers your watch should last approximately 2 years. [. . . ] If not, shirt sleeves may be stained and those with delicate skin may develop a rash. Please wear the watch with some play to avoid any possible allergic reaction. If you develop a rash on your wrist, stop wearing and consult a physician. · MAGNETISM Your watch will not be affected by magnetism generated by household electric appliances. [. . . ]