User manual LOWRANCE EP-90R PRESSURE SENSOR QUICK GUIDE

[. . . ] 988-0154-641 EP-90R Pressure Installation and Configuration Instructions This document shows how to install an EP-90R Pressure sensor and how to connect it to a NMEA 2000® network. It also provides instructions on how to configure your pressure sensor with Lowrance digital gauges (LMF-200 & LMF-400) and display units. NMEA 2000 is the communication bus standard developed by the National Marine Electronics Association (NMEA) for use in boats. Lowrance has introduced a line of products that can communicate over a NMEA 2000 network (LowranceNet). [. . . ] Use the ENTER and EXIT keys to scroll the Single Analog page onto the main display. Press MENU, use the UP and DOWN keys to select CUSTOMIZE and press ENTER. Select PITOT SPEED, ENG BST PRESS, ENG OIL PRESS, ENG WTR PRESS, FUEL PRESSURE, TRNS OIL PRESS or ATM PRESSURE and press ENTER. The Select Engine menu will appear with up to three options. (If your unit is set to a single-engine configuration, or if you chose Pitot Speed or ATM Pressure, you will be taken back to the Bus Devices list. ) 5. Select the desired engine and press ENTER. You will be taken back to the Bus Devices list. Press EXIT repeatedly to return to the main display. To customize Dual Analog page: 1. Make sure the Dual Analog page has been added to the page screen rotation. Use the ENTER and EXIT keys to scroll the Dual Analog page onto the main display. Press MENU, use the UP and DOWN keys to select CUSTOMIZE and press ENTER. The Position menu will appear with two options: Top Gauge and Bottom Gauge. Select the desired position and press ENTER. Highlight PITOT SPEED, ENG BST PRESS, ENG OIL PRESS, ENG WTR PRESS, FUEL PRESSURE, TRNS OIL PRESS or ATM PRESSURE and press ENTER. The Select Engine menu will appear with up to three options. (If your unit is set to a single-engine configuration, or if you chose Pitot Speed or ATM Pressure, you will be taken back to the Position menu. ) 6. Select the desired engine and press ENTER. You will be directed to the Position menu. Repeat steps 4-6 to customize the other position or press EXIT repeatedly to return to the main display. 18 To customize Quad Analog page: 1. Make sure the Quad Analog page has been added to the page screen rotation. Use the ENTER and EXIT keys to scroll the Quad Analog page onto the main display. [. . . ] Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. This warranty does NOT apply in the following circumstances: (1) when the product has been serviced or repaired by anyone other than us; (2) when the product has been connected, installed, combined, altered, adjusted, or handled in a manner other than according to the instructions furnished with the product; (3) when any serial number has been effaced, altered, or removed; or (4) when any defect, problem, loss, or damage has resulted from any accident, misuse, negligence, or carelessness, or from any failure to provide reasonable and necessary maintenance in accordance with the instructions of the owner's manual for the product. We reserve the right to make changes or improvements in our products from time to time without incurring the obligation to install such improvements or changes on equipment or items previously manufactured. This warranty gives you specific legal rights and you may also have other rights which may vary from state to state. [. . . ]