User manual LOWRANCE GLOBALMAP 2000

[. . . ] GlobalMap 2000 INSTALLATION AND OPERATION INSTRUCTIONS TM Copyright © 1997, 1998 Lowrance Electronics, Inc. GlobalMap 2000TM is a trademark of Lowrance Electronics Lowrance® is a registered trademark of Lowrance Electronics WARNING!USE THIS UNIT ONLY AS AN AID TO NAVIGATION. A CAREFUL NAVIGATOR NEVER RELIES ON ONLY ONE METHOD TO OBTAIN POSITION INFORMATION. [. . . ] A message appears on the screen that warns you that this waypoint will be permanently erased. If you still wish to erase this waypoint, press the ENT key. The waypoint location will return to "Empty". Press the CLR key to return to the map, steer, or navigation screen. WAYPOINT DISPLAY There are a number of options available when showing the waypoint location on the map. You can show all waypoints or turn them off, show only the symbols, names, or number, or any combination of these. To change the waypoint display, first press the MENU key, then press the key next to the "Mapping Setup" label. Now press the key next to the "More. . . " label. The screen shown at the bottom of the previous page appears. Press the key next to the desired option, then press the CLR key to exit this screen. The defaults for this screen are: all waypoints on, waypoint symbols on, waypoint names off, and waypoint numbers on. ROUTES A route gives you the ability to navigate to several waypoints without having to reprogram the unit after arriving at each one. A route consists of two or more waypoints. When you travel on a route, the GlobalMap 2000 shows navigation information to the first waypoint in the route. When you reach the first waypoint, (signalled by the Arrival Alarm), the unit automatically 49 sequences to the next waypoint. Navigation information is shown to this waypoint and the process repeats. When you reach the last waypoint in a route, the arrival alarm sounds until you turn it off. There are four steps required to create and follow a route. First, you must create and name the route. Next, select the waypoints used in the route. Next, tell the unit to follow the route. Finally, the unit will ask you if you wish to run the route forward or backward. [. . . ] Check, money order, Visa, or MasterCard may be used. 5. Fill in your name, address, zip code, date, and RA number in the blanks provided on the UPS form included with your unit. 6. Attach the label to the shipping box, tear off the tab for your receipt and give the package to any UPS driver or take the package to any UPS Customer Center. You will not be charged for this shipment. [. . . ]