User manual LOWRANCE GLOBALMAP 5300C IGPS

[. . . ] 988-0152-191 GlobalMap® 5300c iGPS Mapping GPS Receiver Operation Instructions Copyright © 2006 Lowrance Electronics, Inc. All rights reserved. No part of this manual may be copied, reproduced, republished, transmitted or distributed for any purpose, without prior written consent of Lowrance. Any unauthorized commercial distribution of this manual is strictly prohibited. Lowrance® is a registered trademark of Lowrance Electronics, Inc. [. . . ] When the point has been selected, press ENT and you will be directed to the Waypoint information menu. There will be two options: Set Reference or Find on Map. Highlight Set Reference and press Enter. Press or to change the first character, then press to the next character and repeat until the distance is correct. Press or to change the first character, then press to the next character and repeat until the bearing is correct. You can simply save the new projected waypoint by pressing EXIT|EXIT or you can edit the waypoint. (Press EXIT|ENT if you want to immediately begin navigating to the new waypoint. ) 72 Section 5: System & GPS Setup Alarms This unit has several GPS alarms. The factory default setting has all of these but the anchor alarm turned on. You can turn the alarms off and on and change their distance settings. You can set an arrival alarm to flash a warning message and sound a tone when you cross a preset distance from a waypoint. For example, if you have the arrival alarm set to . 1 mile, then the alarm will flash a message when you come within . 1 mile of the recalled waypoint. The off course alarm warns you when your track drifts too far to the right or left of the course line to the waypoint. For example, if the alarm is set to . 1 mile, then the alarm flashes a message if you drift . 1 of a mile or more to the right or left of the line to the waypoint. The anchor alarm is triggered when you drift outside of a preset radius. Again, using the . 1 mile as an example, if you're anchored and your boat moves more than . 1 of a mile, the alarm will flash a message and sound a tone. Alarms command (left). Alarm menu (right). To change alarm settings: 1. Scroll to select the desired category, then press ENT to check or clear the Enabled box. This turns the alarm on (checked) or off (unchecked. ) 73 3. To change distance settings, scroll to select the desired category, then press |ENT to activate the distance dialog box. Use to change the first character, then press to the next character and repeat until the name is correct. When your adjustments are finished, return to the last page displayed by repeatedly pressing EXIT. IMPORTANT ALARM NOTES Anchor Alarm - The anchor alarm may be triggered even when you are sitting still. [. . . ] Before any product can be returned, you must call customer service to determine if a return is necessary. Many times, customer service can resolve your problem over the phone without sending your product to the factory. To call us, use the following toll-free number: 800-661-3983 905-629-1614 (not toll-free) 8 a. m. Eastern Standard Time, M-F . . . outside Canada and the USA: If you have technical, return or repair questions, contact the dealer in the country where you purchased your unit. [. . . ]