User manual LOWRANCE GLOBALMAP 540C BAJA

[. . . ] 988-0151-481 GlobalMap® 540c BAJA Mapping GPS Receiver Operation Instructions Copyright © 2006 Lowrance Electronics, Inc. No part of this manual may be copied, reproduced, republished, transmitted or distributed for any purpose, without prior written consent of Lowrance. Any unauthorized commercial distribution of this manual is strictly prohibited. Lowrance® is a registered trademark of Lowrance Electronics, Inc. [. . . ] Press EXIT, which will open the Waypoint Information menu with up to four options: Go To Waypoint, Find on Map, Edit Waypoint and Delete Waypoint. Select the desired option and press ENT. 73 Set a Waypoint by Average Position This feature sets a waypoint at the current position after taking several position readings and averaging them. This boosts waypoint position accuracy by helping to eliminate errors caused by atmospheric conditions and other factors. Press WPT| to SUBCATEGORY column| to NEW|ENT. Press or to AVERAGE POSITION|ENT|press to CREATE|ENT. Wait while the unit takes points to average for the position. (The greater the number of points, the greater the accuracy. ) When the desired number of points accumulates, press ENT to create and save the waypoint. You can simply save the waypoint by pressing EXIT|EXIT or you can edit the waypoint. Set a Waypoint by Projecting a Position This feature sets a waypoint at a point located a specific distance and bearing from a reference position. The reference position can be selected from your waypoint list, a map feature or from the Points of Interest list. Press WPT| to SUBCATEGORY column| to NEW|ENT. Press to PROJECTED POSITION|ENT| to CREATE|ENT. Use and to select a waypoint, map feature or Point of Interest. When the point has been selected, press ENT and you will be directed to the Waypoint information menu. There will be two options: Set Reference or Find on Map. Highlight Set Reference and press Enter. Press or to change the first character, then press to the next character and repeat until the distance is correct. Press or to change the first character, then press to the next character and repeat until the bearing is correct. You can simply save the new projected waypoint by pressing EXIT|EXIT or you can edit the waypoint. (Press EXIT|ENT if you want to immediately begin navigating to the new waypoint. ) 74 Section 5: System & GPS Setup Alarms This unit has several GPS alarms. The factory default setting has all of these but the anchor alarm turned on. [. . . ] Before any product can be returned, you must call customer service to determine if a return is necessary. Many times, customer service can resolve your problem over the phone without sending your product to the factory. To call us, use the following toll-free number: 800-661-3983 905-629-1614 (not toll-free) 8 a. m. Eastern Standard Time, M-F . . . outside Canada and the USA: If you have technical, return or repair questions, contact the dealer in the country where you purchased your unit. [. . . ]