User manual LOWRANCE GLOBALMAP 6500C

[. . . ] 988-0151-331 www. lowrance. com GlobalMap 6500C, GlobalMap 6600C HD, GlobalMap 7500C, GlobalMap 7600C HD, ® ® ® ® Mapping GPS Receivers Operation Instructions Copyright © 2005 Lowrance Electronics, Inc. No part of this manual may be copied, reproduced, republished, transmitted or distributed for any purpose, without prior written consent of Lowrance Electronics. Any unauthorized commercial distribution of this manual is strictly prohibited. Lowrance is a registered trademark of Lowrance Electronics, Inc. [. . . ] Press to DELETE TRAIL| to NAVIGATE|ENT. Press to NAVIGATE| to REVERSE|ENT| to NAVIGATE|ENT. The unit begins showing navigation information along the trail, in reverse. 54 NOTE: If you are already located at or near the end of your trail, the arrival alarm will go off as soon as you hit ENT. Just press EXIT to clear the alarm and proceed. Begin moving and let your GlobalMap guide you. When you reach your destination, be sure to cancel your navigation. Press MENU|MENU| to CANCEL NAVIGATION|ENT. Press |ENT. Transfer Custom Maps and GPS Data Files Custom Maps Custom maps work only from the MMC card or SDC card. When a card containing a Custom Map File is loaded into the unit, it automatically loads the map into memory when the unit is turned on. Instructions for copying Custom Map Files to an MMC are contained in the instruction manual for your MMC card reader and MapCreate 6 software. For instructions on inserting an MMC into the GlobalMap, see Sec. NOTE: To load a Navionics chart, see Sec. GPS Data files GPS Data Files contain waypoints, routes, trails and event marker icons. Instructions for copying GPS Data Files between your computer and an MMC are contained in the instruction manual for your MMC card reader and MapCreate 6 software. GPS data automatically recorded in the unit's internal memory must be saved to the MMC (as a GPS Data File) in order to store it on your personal computer. GPS Data Files stored on an MMC must be copied from the card to the GlobalMap's internal memory before the unit can read them. Press MENU|MENU| to SYSTEM SETUP|ENT| to TRANSFER MY DATA|ENT and the screen below appears. 55 The Transfer My Data submenu asks if you want to save data to the MMC or load data from the MMC into the unit's memory. 2. The Transfer My Data menu includes a message that tells you if a MMC is present or not. If no MMC is present, you must insert a card to activate the Load or Save commands. To transfer data from the GlobalMap to the MMC press ENT (for SAVE. ) To transfer data from the MMC to the GlobalMap press to LOAD|ENT. 3. Saving to MMC: To accept the default name "Data" for the GPS Data File, press to SAVE DATA|ENT. If you wish to rename the file (as shown in the following figures), press ENT to activate the file name selection box. [. . . ] We reserve the right to do so without notice. . . . in Canada: If you're in Canada and you have technical, return or repair questions, please contact the Factory Customer Service Department. Before any product can be returned, you must call customer service to determine if a return is necessary. Many times, customer service can resolve your problem over the phone without sending your product to the factory. To call us, use the following toll-free number: 905-629-1614 (not toll-free) 8 a. m. [. . . ]