User manual LOWRANCE GLOBALMAP BAJA 480C

[. . . ] 988-0151-281 www. lowrance. com ® GlobalMap Baja 480C Mapping GPS Receiver Operation Instructions Copyright © 2005 Lowrance Electronics, Inc. No part of this manual may be copied, reproduced, republished, transmitted or distributed for any purpose, without prior written consent of Lowrance Electronics. Any unauthorized commercial distribution of this manual is strictly prohibited. Lowrance is a registered trademark of Lowrance Electronics, Inc. [. . . ] When you reach your destination, be sure to cancel your navigation: press MENU|MENU| to CANCEL NAVIGATION|ENT. The unit asks if you're sure; press |ENT. Figure 1. Figure 2. Figure 3. Figure 4. Navigate a trail menu sequence: Fig. 4, Edit Route Menu with Navigate command highlighted for Trail 6. A trail is always converted to a "route" when you navigate the trail. 51 On the Map Page, the trail you are navigating is represented by a dotted line that alternates with a flashing solid line. The Navigation Page will also show the navigated trail as a dotted line. The bearing arrow on the compass rose points to the next waypoint on the trail. As you travel, the arrival alarm will go off when you near a trail waypoint, and the bearing arrow on the compass rose will swing around and point to the next trail waypoint. Press EXIT to clear the alarm. North Present position arrow Trail point Trail dotted line Navigate trail, map views: at left driver is northbound heading straight toward trail point 6. At right, northbound driver has reached point 6 and has turned west to follow trail. Track or compass heading indicator Trail waypoint symbol Course line made from trail Cross track error range (off course indicator) Bearing arrow Arrival alarm Navigate trail, navigation page (compass rose) views: driver (left) is northbound heading straight toward trail point 6; bearing arrow shows the trail point is due north (straight ahead. ) driver (right) has reached trail point 6 and must turn west to follow the trail. Arrival alarm goes off and bearing arrow swings around to say turn left (west), toward the next waypoint, trail point 7. The unit now shows navigation information to point 7, which is 2. 02 miles away. Navigate a Back Trail (backtrack, or reverse) 1. Press | to enter the Saved Trail list, then use or to select the desired Trail Name|ENT. Press to DELETE TRAIL| to NAVIGATE|ENT. Press to NAVIGATE| to REVERSE|ENT| to NAVIGATE|ENT. The unit begins showing navigation information along the trail, in reverse. NOTE: If you are already located at or near the end of your trail, the arrival alarm will go off as soon as you hit ENTER. Just press EXIT to clear the alarm and proceed. When you reach your destination, be sure to cancel your navigation: press MENU|MENU| to CANCEL NAVIGATION|ENT. The unit asks if you're sure; press |ENT. Transfer Custom Maps and GPS Data Files Custom Maps: Custom maps work only from the MMC card or SD card. When a card containing a Custom Map File is loaded into the unit, the unit automatically loads the map into memory when the unit is turned on. [. . . ] We reserve the right to do so without notice. . . . in Canada: If you're in Canada and you have technical, return or repair questions, please contact the Factory Customer Service Department. Before any product can be returned, you must call customer service to determine if a return is necessary. Many times, customer service can resolve your problem over the phone without sending your product to the factory. To call us, use the following toll-free number: 800-661-3983 905-629-1614 (not toll-free) 8 a. m. [. . . ]