User manual LOWRANCE IFINDER HUNT

[. . . ] 988-0148-481 www. lowrance. com Handheld Mapping GPS Receiver Operation Instructions Copyright © 2004 Lowrance Electronics, Inc. No part of this manual may be copied, reproduced, republished, transmitted or distributed for any purpose, without prior written consent of Lowrance. Any unauthorized commercial distribution of this manual is strictly prohibited. iFINDER HUNT and Lowrance® are registered trademarks of Lowrance Electronics, Inc. [. . . ] To select a file, press ENT to activate the selection box, use or to highlight the file, then press ENT to accept the selection. The unit will display a completion message when the data transfer is finished. To return to the Page view, press EXIT|EXIT|EXIT. Navigate Navigation is one of the most powerful reasons for owning an iFINDER. With the navigation options available you can get accurate information about where you want to go, how to get there, how long it will take, and other useful trip information. Navigate Back Home You can navigate to the "Home" waypoint created in Easy Mode, but you must use Advanced Mode's procedure for navigating to a waypoint. See the entry later in this section on Navigate to a Waypoint. Navigate Back to Man Overboard Waypoint This unit has a man overboard feature that shows navigation data to the location where the feature was activated. To activate it, press the ZOUT and ZIN keys at the same time. Your position at the time these keys are pressed is used as the man overboard position. The unit automatically begins navigating to the MOB waypoint. For further details, see this subject in Sec. 3, Easy Mode Operation. 51 Cancel Navigation In Easy Mode: Press MENU| to CANCEL NAVIGATION|ENT| to YES|ENT. In Advanced Mode Press MENU|MENU| to CANCEL NAVIGATION|ENT| to YES|ENT. Navigate a Route 1. From the NAVIGATION PAGE, press MENU|ENT or from the MAP PAGE, press MENU|MENU| to ROUTE PLANNING|ENT. Upon arrival at your destination, cancel navigation: press MENU|MENU| to CANCEL NAVIGATION|ENT| to YES |ENT. Use arrow keys to center cursor cross-hair over the map object or location. To navigate to the selected location: press MENU|ENT|EXIT. Follow steering arrow on Map Page or compass bearing arrow on Navigation Page. Navigate to an Icon Use the Navigate to Cursor command above, and use the cursor to select the icon. Navigate to Point of Interest (POI) For POIs that are in view on the map, you can easily use the Navigate to Cursor command above; just use the cursor to select the POI. The other method involves searching for POIs with the Find command. 6, Searching, for detailed instructions on POI searches. ) Whenever you locate a POI, the Point of Interest information screen appears (with phone number, position, etc. ) and the GO TO command is automatically highlighted in the command box. To navigate to that POI, press ENT and iFINDER begins displaying navigation information to that location. [. . . ] We reserve the right to do so without notice. . . . in Canada: If you're in Canada and you have technical, return or repair questions, please contact the Factory Customer Service Department. Before any product can be returned, you must call customer service to determine if a return is necessary. Many times, customer service can resolve your problem over the phone without sending your product to the factory. To call us, use the following toll-free number: 905-629-1614 (not toll-free) 8 a. m. [. . . ]