User manual LOWRANCE IFINDER M-M

[. . . ] 988-0148-631 www. lowrance. com Mapping GPS & MP3 Player Operation Instructions Copyright © 2004 Lowrance Electronics, Inc. No part of this manual may be copied, reproduced, republished, transmitted or distributed for any purpose, without prior written consent of Lowrance. Any unauthorized commercial distribution of this manual is strictly prohibited. iFINDER Map & Music and Lowrance® are registered trademarks of Lowrance Electronics, Inc. [. . . ] Navigate to Point of Interest (POI) For POIs that are in view on the map, you can easily use the Navigate to Cursor command above; just use the cursor to select the POI. Another method involves searching for POIs with the Find Map Places command, launched with the FIND key. 6, Searching, for detailed instructions on POI searches. ) After you have looked up an item with the Find Map Places command, use the to make sure the GO TO command is highlighted at the bottom of the screen, then press ENT. iFINDER begins showing navigation information to the item. To cancel navigation, press MENU|MENU| to CANCEL NAVIGATION|ENT| to YES|ENT. The iFINDER stops showing navigation information. 40 Navigate to a Waypoint You can select any waypoint visible on the Map Page with the cursor, then use the Navigate to Cursor command. However, you can avoid scrolling the map to pick your waypoint if you use the Find commands: 1. To look up the nearest waypoint, press ENT, or to look by name (and scroll through the entire waypoint list), press |ENT. If your waypoint list is a long one, you can spell out the waypoint name in the FIND BY NAME box to search for it. (Press or to change the first character, then press to move the cursor to the next character and repeat until the name is correct, then press ENT to jump to the list below. ) 3. If the list is short, you can jump directly to the FIND IN LIST box by pressing ENT. Use or to select the waypoint name, press ENT and the waypoint information screen appears with the GO TO command selected. To begin navigating to the waypoint, press ENT. Press MENU|MENU| to MY TRAILS|ENT and a screen similar to the one below appears. Trails Menu. 2. Press then use or to select a trail to navigate. With the trail name highlighted, press ENT| to NAVIGATE|ENT. Wait while iFINDER creates a route from the trail. When the progress message disappears, the unit displays a trail information screen, with the NAVIGATE command highlighted in the top command box. 41 Tip: Back Track a Trail Simply running the Navigate command will lead you along the trail from its starting point to its ending point -- forward order. You can also back track a trail, or follow it in reverse order (from its ending point to its starting point. ) First select the Reverse command to reverse the trail point order before you start navigating: press to REVERSE|ENT| to NAVIGATE. The unit begins showing navigation data along the trail. [. . . ] We reserve the right to do so without notice. . . . in Canada: If you're in Canada and you have technical, return or repair questions, please contact the Factory Customer Service Department. Before any product can be returned, you must call customer service to determine if a return is necessary. Many times, customer service can resolve your problem over the phone without sending your product to the factory. To call us, use the following toll-free number: 905-629-1614 (not toll-free) 8 a. m. [. . . ]