User manual LOWRANCE LCX-110C

[. . . ] 988-0151-311 www. lowrance. com LCX-25C; LCX-26C HD LCX-110C; LCX-111C HD Fish-finding Sonar & Mapping GPS Operation Instructions Copyright © 2005 Lowrance Electronics, Inc. No part of this manual may be copied, reproduced, republished, transmitted or distributed for any purpose, without prior written consent of Lowrance Electronics. Any unauthorized commercial distribution of this manual is strictly prohibited. Lowrance is a registered trademark of Lowrance Electronics, Inc. [. . . ] Then press or to select a different data option. With the new option highlighted, press ENT to switch the contents of the box to the new data type, then press EXIT. You can now select another box to change. When you are finished with the settings, press EXIT again and the box name stops flashing. NOTE A Page display can only show a limited number of data boxes. FlashGraf The FlashGraf sonar page option represents a flasher style sonar combined with a scrolling chart. A circular dial shows all returning echoes at a high screen refresh rate. It uses the Colorline feature to show weaker targets as darker colors. The bottom depth is shown as a black bar across the outer circle. 83 You can adjust the size of the chart and the flasher windows by using the Resize Window command, which is described on page 105. Surface clutter Bottom signal FlashGraf page. Fish signal, approximately 27 feet Map With Sonar Split Screen There is a page mode that splits the screen in half, with the map on the left and the sonar on the right. This screen option can be found on the Pages Menu under the Map Page category. Map with Sonar split screen. When this screen is activated, you need to specify which side of the Menu, is active. To toggle between the two windows, press PAGES|PAGES. The window with the blue title bar at the top of the screen is the active window. To switch back, just press PAGES|PAGES again. Sonar Simulator This unit has a built-in simulator that lets you run it as if you were on the water. All sonar features and functions are useable. When in 84 simulator mode, you will see the chart file name in the Sonar Page title bar and a play symbol will flash on and off at the right end of the title bar. From the Sonar Page, press MENU|MENU| to SONAR SETUP|ENT| to SONAR SIMULATOR ENT|ENT. Main Menu with Sonar Setup command selected (left). Sonar Simulator menu, with simulator turned on (right). NOTE: With Simulate Position checked, the simulator will also automatically run the GPS simulator (if GPS data was recorded with the sonar log). To use the default sonar chart log stored in the unit, press EXIT. The recorded chart begins scrolling across the screen, just as if you were on the water. Turn off the Sonar Simulator by pressing MENU|MENU| to SONAR SETUP|ENT| to SONAR SIMULATOR|ENT|ENT|EXIT. "Play" symbol flashing Title bar with chart file name The Sonar Page playing a recorded sonar chart in Simulator mode. Tip: The Sonar Simulator can use sonar charts recorded (logged) on a MMC card. (To see how, read the entry in this section on Log Sonar 85 Chart Data. ) To play back a sonar chart, make sure the MMC containing the chart is installed, then: 1. [. . . ] We reserve the right to do so without notice. . . . in Canada: If you're in Canada and you have technical, return or repair questions, please contact the Factory Customer Service Department. Before any product can be returned, you must call customer service to determine if a return is necessary. Many times, customer service can resolve your problem over the phone without sending your product to the factory. To call us, use the following toll-free number: 800-661-3983 905-629-1614 (not toll-free) 8 a. m. [. . . ]