User manual LOWRANCE RADAR OPERATION ADDENDUM I

[. . . ] 988-0161-10B Radar Operation Instruction Manual Copyright © 2008 Navico. No part of this manual may be copied, reproduced, republished, transmitted or distributed for any purpose, without prior written consent of Navico. Any unauthorized commercial distribution of this manual is strictly prohibited. Lowrance® is a registered trademark of Navico. NMEA 2000® is a registered trademark of the National Marine Electronics Association. Navico may find it necessary to change or end our policies, regulations and special offers at any time. [. . . ] Use to adjust the Interference Rejection. Press EXIT. Radar Range selected (left). List of radar ranges (right). Radar Range This feature allows you to expand the area shown on the display unit, allowing you to see distant targets. You also can decrease the range to focus on targets closing in on you. 17 To adjust radar range: 1. Press MENU, select RADAR RANGE and press ENT. 2. Use to select the desired range and press ENT. NOTE: When switching radar ranges, you likely will need to adjust Gain, STC and FTC settings to achieve optimum performance. You can also adjust radar range by pressing the ZIN or ZOUT keys. Radar Echo Expansion The Radar Echo Expansion feature will make weak signals more visible on the display by lengthening radar echoes. To turn Radar Echo Expansion On/Off: 1. Press MENU, highlight RADAR ECHO EXPANSION and press ENT to turn it on (check) or turn it off (uncheck). Press EXIT. Tip: Remember, when Echo Expansion is on, all signals on the display will be enlarged, including clutter. Echo Trail Interval The Echo Trail Interval feature displays an on-screen history (trail) of the movements of all radar targets. To adjust Echo Trail Interval 1. Press MENU, select ECHO TRAIL INTERVAL and press ENT. The Echo Trail Interval menu will display a series of intervals with options ranging from Continuous to Off. Use to highlight the desired interval and press ENT. NOTE: This feature is best used in open water or when your vessel is stationary and you are tracking a moving target. If Echo Trail Interval is on and your vessel is moving, the display will be crowded with trails for every target, including stationary targets, like lighthouses and land. Clear Radar Trails This feature is used to clear radar trails created with the Echo Trail Interval command. To clear radar trails: 1. Press MENU, highlight CLEAR RADAR TRAILS and press ENT. Log Radar Data If your unit has a hard drive (LCX-28cHD, LCX-38cHD, LCX-113cHD GlobalMap 6600cHD, GlobalMap 7300cHD GlobalMap 7600cHD, 18 GlobalMap 8300cHD and GlobalMap 9300cHD) the Log Radar Data feature will be available on the Radar menu, allowing you to save radar logs. Saving a radar log allows you to reuse the log in the unit's simulator. If your unit does not have a hard drive you will not see the Log Radar Data command on your Radar menu. Log Radar Data menu. Press MENU, select LOG RADAR DATA and press ENT. 2. [. . . ] We reserve the right to do so without notice. . . . in Canada: If you're in Canada and you have technical, return or repair questions, please contact the Factory Customer Service Department. Before any product can be returned, you must call customer service to determine if a return is necessary. Many times, customer service can resolve your problem over the phone without sending your product to the factory. To call us, use the following toll-free number: 905-629-1614 (not toll-free) 8 a. m. [. . . ]