User manual LT EQUIPMENT REFLEX ZONE

[. . . ] REFLEX ZONE LT EQUIPMENT, INC. 6020 North Bailey Avenue, Suite 2 PO Box 930 Amherst, NY 14226 (716) 833-8819 ™ Manufacturers of Interactive Entertainment PLEASE FILL OUT THE FOLLOWING FOR FUTURE REFERENCE: SER. __RZ-2000A__ Installation, Settings, and ServiceManual 1 MANUFACTURER’S OF INTERACTIVE ENTERTAINMENT Installation, Settings, and Service Manual © LT Equipment, Inc. 6020 North Bailey Avenue, Suite 2 Amherst, NY 14226 (716) 833-8819 i Table of Contents Introduction Table of Contents I II Game License Repair Cautions Test Mode 1- I NSTA LLATI ON Safety First: Electrical and Grounding Requirements Indoor Use Only Quick Start for Linking 2 or more Cabinets Important Linked-Game Information Linked Game Units (Diagram-A) Linked Game Units (Diagram-B) Linking-Important Notes Powering On and Testing Reflex Zone 3 4 5 6 7 8-9 1 2 Troubleshooting Contacting the Manufacturer Cabinet Diagram (exterior front view) Race Button Panel Cabinet Diagram (fastener locations) Lower Display Boards (layer A) Lower Display Boards (layer B) Lower Display Boards (layer C) Cabinet Diagram (interior view) MPU Board Volume Control Link Modular Wall Jack Assembly 2- SETTI NGS Configuration Table Ticket Payout Table Programming New Settings 11-12 13 14-15 Cabinet Diagram (exterior rear view) Coin Mech and Ticket Motor Diagram (exterior view) Coin Mech and Ticket Motor Diagram (interior view) Coin Mech Information Ticket Dispenser Information Parts Listing 3-SERVI CE Warranty 20 Cable Listing/Chart Harness Schematics Cleaning Notes 41 42 42 43 44-45 46 47 48 40 21 22 22-25 26-29 30 31 32 33 34 34 35 36 37 37 38 39 Restoring the Factory Default Settings15-17 Internal Switch “ID” Settings(MPU) Rotary Switch “ID” Settings(CoinMech) 17 18 ii R E F L E X Z O N E : I N S T A L L A T I O N Installation Installation 1 P I C O N K E Y rior to providing power to your new game, please read through the following pages in this section. The pages will allow you to become aware of the proper electrical and installation requirements for your new game. [. . . ] CABINET# 1 2 3 4 5 6 7 8 ROTARY SWITCH SETTING 0 1 2 3 4 5 6 7 18 R E F L E X Z O N E : S E R V I C E Service Service This section will explain and help you with the basics, such as - Warranty Information, Repair Cautions, Troubleshooting, Parts Listings, Diagrams, and Cleaning Guidelines. 3 19 R E F L E X Z O N E : S E R V I C E Warranty Limited Warranty. a) LT Equipment, Inc. (LTE) warrants for ninety (90) days from Delivery that all the components in the REFLEX ZONE™ game, when shipped, will be free from defects in materials comprising the same and in LTE’s workmanship. LTE will, at its own expense and option, either repair or replace any defective component of the REFLEX ZONE™ game, provided that Purchaser has notified LTE in writing within ninety (90) days after Delivery, and upon inspection, LTE has found such REFLEX ZONE™ game component to be defective and covered by this limited warranty. The Purchaser’s sole and exclusive remedy will be limited to such repair or replacement f. o. b. The warranties set out above do not cover accidents, fire, theft, neglect, abuse, acts of God or other such casualties, or any other conditions or events occurring external to the REFLEX ZONE™ game other than those caused by LTE which directly result in a failure or malfunction or otherwise adversely affect the operation of the REFLEX ZONE™ game. The warranties set out above also do not cover damage from normal wear and tear, improper modification, assembly, or improper repairs made on the REFLEX ZONE™ game. LTE will assume no liability whatsoever, for costs associated with labor to replace defective parts, or travel time associated therein. LTE’s obligation will be to ship free of charge, replacement parts by UPS Ground, U. S. Mail, or other comparable shipping means. Any Express Mail or Overnight shipping expense is at the cost of the purchaser. Products will be covered under the warranty only when: 1. The serial number of the game with the defective part is given. The serial number of the defective part, if applicable, is given. Defective parts are returned to LTE, shipping prepaid, in a timely fashion, if requested by LTE. A copy of the sales receipt is available as proof of purchase upon request by LTE. b) c) d) e) f) LTE distributors are independent, privately owned and operated. In their judgment, they may sell parts or accessories other than those manufactured by LTE. We can not be responsible for the quality, suitability, or safety of any non-LTE part, or any modification, including labor, which is performed by such distributor. THIS EXPRESS LIMITED WARRANTY SET FORTH IN THIS AGREEMENT IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS, IMPLIED OR STATUTORY, ALL OF WHICH LTE HEREBY EXPRESSLY DISCLAIMS, INCLUDING WITHOUT LIMITATION, ANY WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. g) 20 R E F L E X Z O N E : S E R V I C E Game License REFLEX ZONE™ LICENSES. a) LT Equipment, Inc. (LTE) hereby grants to Purchaser a transferable, non-exclusive, revocable license: i) to operate the REFLEX ZONE™ game (“Equipment”) with LT Equipment, Inc’s (LTE) Trademark “REFLEX ZONE™” (“Mark”) affixed to such Equipment solely in the manner LTE has applied the Mark to the Equipment prior to shipment; and to utilize the software and circuitry included with the Equipment solely to operate the Equipment. . LTE owns or possesses by license sufficient rights to use the Mark, Software and Circuitry in the manner affixed to and/or incorporated within the Equipment. Notwithstanding anything herein to the contrary, Purchaser shall not use the Mark to identify its business organization, or its facilities or the locations at which the Equipment is located, nor to identify any other product or service offered by Purchaser or any parent, subsidiary or affiliated person, firm, corporation, partnership or entity of Purchaser. ii) b) Purchaser acknowledges that the Mark, Circuitry and Software are the exclusive property of LTE and that Purchaser does not have and will not at any time hereafter have or claim directly or indirectly any right, title or ownership interest in or to the Mark, Circuitry and/or Software. Purchaser acknowledges that no other right or license is granted by LTE to Purchaser, either express or implied, with respect to any other trademark, trade name, service mark, or other intellectual property right owned, possessed, or licensed by or to LTE. Purchaser shall not alter or use the Mark, Circuitry and/or Software in any manner not specifically authorized by this Agreement. c) 21 R E F L E X Z O N E : S E R V I C E Repair Cautions Before servicing Reflex Zone, be sure to read the WARNING below: ¨ WARNING: Power Game OFF before Servicing Failure to remove the power from Reflex Zone, prior to Servicing, may result in serious injury to yourself and/or others. Test Mode To verify that all the major components of your Reflex Zone are working properly, please follow the procedure listed below: 1. On the back of the Reflex Zone cabinet is a main power switch. [. . . ] Confirm that the Com Cable from the MPU to the Coin Mech Interface Board “Com” is attached and that there are no open wires. If the cabinet was intended to be Linked, its ID# may have been already set to be a Linked Cabinet(ID#’s 001-007) in Option#9. However, the Game Configuration Table Option#000 may be set to Un-Linked AND either the Internal or External Link Cable is not attached. Unable to Enter into the Configuration 1. Button harness wires disconnected or have open wires. [. . . ]