User manual LUMAGEN VISION BROCHURE

[. . . ] Vision Video Processor User Manual and Installer Guide LEGAL NOTICES: BEFORE USING THIS PRODUCT YOU MUST ACCEPT THE TERMS OF THE LICENSE AGREEMENT. IF YOU DO NOT AGREE TO BE BOUND THE TERMS OF THE LICENSE AGREEMENT, RETURN THE PRODUCT TO THE POINT OF SALE IMMEDIATELY. BY DISASSEMBLING OR USING THE PRODUCT, YOU ACCEPT ALL TERMS OF THE LICENSE AGREEMENT. TO THE EXTENT NOT PROHIBITED BY LAW, IN NO EVENT SHALL LUMAGEN, ITS SUPPLIERS, OR ITS DEALERS, BE HELD LIABLE FOR INJURY TO PERSONS OR PROPERTY, ANY LOST REVENUE, LOST PROFIT, SPECIAL, INCIDENTAL, INDIRECT, CONSEQUENCIAL, OR PUNITIVE DAMAGES, IMPAIRMENT OF OR DAMAGE TO OTHER GOODS, HOWEVER CAUSED REGARDLESS OF THE THEORY OF LIABILITY, RESULTING FROM THE USE OF, OR INABILITY TO USE, THIS PRODUCT, EVEN IF LUMAGEN, ITS SUPPLIERS, OR ITS DEALERS, HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. [. . . ] This shows as a screen-width horizontal-band of intensity variation. Since the Lumagen case "floats" it may need to be grounded to the video source and/or display. · Component DVD sources provide the best standard-definition picture quality, but SVideo sources are often a bigger challenge and therefore can show more improvement using Lumagen. Since many satellite receivers, and other video sources, only have composite and SVideo outputs, this improved SVideo performance is important for many installations. · Memory A (MEMA) and memory B (MEMB) can be used to have two independent configurations, such as for day (bright room) and night (dark room). One difference for this example is that the black level will be set higher for daylight viewing than for viewing in a darkened room. To program MEMB to be different, first setup MEMA normally, use the input copy command to copy to MEMB, than adjust MEMB as desired. Remember to save changes. © 2003 Lumagen, Inc. 12 Rev 1. 13 VisionTM User Manual and Installer Guide Command Format Vision commands are selected with the supplied infrared remote. To prevent possible command conflict, only one of these inputs should be used at a time. The infrared remote control command notation is described below: · Remote buttons are named as shown on the remote in a bold font. · For comma separated lists, press the buttons in the sequence shown. Example: For the list RGBHV, OK, press RGBHV then OK. · For parenthesized lists, select one button from the list. · For square-bracketed lists, press as needed. Example: For the list [ , , , ], press the arrow keys as needed. · For menu commands press the MENU button. The , and arrow keys are used to select the function. The arrow key is used to enter sub-menus. This is shown as: MENU MenuItem MenuItem. · Numerical entries are listed as value. While entering the value, the arrow key acts as a backspace key. · Some commands are activated immediately. [. . . ] The TV decoder analog-to-digital conversion uses 10-bit oversampling A/D's. Three, or four, line adaptive comb-filters for Luma and Chroma reduce cross-luma and cross-chroma artifacts. The pass-through input is actively buffered, has a nominal bandwidth of 300 MHz and a ±1. 1 volt nominal input/output range. It uses a standard female VGA connector. [. . . ]