Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual LUMISCOPE MODEL 1092. We hope that this LUMISCOPE MODEL 1092 user guide will be useful to you.
Lastmanuals help download the user guide LUMISCOPE MODEL 1092.
Detailed instructions for use are in the User's Guide.
[. . . ] · Open battery cover as illustrated. Install or replace two new batteries, making sure the polarities (+ and -) on the battery match the polarities on the case. [. . . ] · The buzzer sounds for about 2 seconds, and the high and low blood pressure are respectively dis-
5
played one above the other. · Unless an error is generated, the measurement results are automatically stored in memory (Up to 7 sets of results can be stored ). When there are already 7 sets of results in memory, the oldest one is automatically erased and overwritten with the newest.
· Blood pressure values and pulse rate are alternately displayed. The unit will continue to display the measurement until power is turned off.
· Turn Power off Press the "Power/Start" switch to turn off. NOTE: To discontinue a measurement for any reason, press the "Power/Start" switch. This causes the "wrist cuff" to rapidly deflate.
Subsequent Measurement
When a measurement needs to be made again, the time between 2 measurements must be at least 10 minutes.
Automatic Power OFF Function
If the unit is left on after measurement, an "Automatic PowerOFF Function" turns the power off after approximately 3 minutes. To continue with another measurement press the "Power/Start" switch to turn the unit on.
6
Memory Recall
· You can recall stored data by pressing the "Memory Recall" switch at any time, EXCEPT while taking a measurement. · Up to 7 sets of measurement results can be stored in memory. 1 is always used to store the newest set of results.
· When pressing the "Memory Recall" switch, the memory cell number is displayed. The stored measurement results (systolic/diastolic blood pressure) are then displayed.
· If the "Memory Recall" switch is pressed again, the prior measurements are displayed in the order they were taken.
Memory Clear Function
While the memory data to be cleared is indicated and the "Memory recall" switch is pressed for 3 seconds, the buzzer will beep and the memory data is cleared.
7
Description of Display Marks
DISPLAY MARK CONDITION/CAUSE CORRECTIVE ACTION
The cuff was inflated to more than 280 mmHg.
Exhaust the air from the cuff.
Pressurization is not possible. [. . . ] This product is not intended to be used in the diagnosis or treatment of disease. If you have high blood pressure and/or other cardiovascular conditions or diseases, this device should be used in consultation with your doctor. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE LUMISCOPE MODEL 1092
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual LUMISCOPE MODEL 1092 will begin.
