User manual LUMISCOPE MODEL 1095

[. . . ] Install or replace four new batteries, making sure the polarities (+ and -) on the battery match the polarities on the case. · Replace the batteries if: - the Low Battery indicator " " appears on the display. - the ON/OFF/START button is pressed and nothing appears on the display. [. . . ] Position the cuff so that the artery mark is in the middle of the arm, in line with the middle finger (fig. G Artery Mark region · Wrap the cuff as close to the skin as possible. (Do NOT roll shirts or jackets up over the arm when taking a measurement. This will constrict the upper arm and prevent accurate measurement. ) · When using the monitor attached to the cuff, the monitor and artery mark should be on the inside of your arm (fig. · When using the monitor as a tabletop unit, the cuff tube should be placed on the inside of your arm (fig. · Make sure that the cuff is fastened firmly. Note that wrapping the cuff unevenly will prevent proper measurement. Fig. H Rest left elbow on a table so that the cuff is at heart level. Relax the lower arm across the table and remain still. Perform measurements in either a seated or reclining posture with the left palm turned upward. Fits Arm Circumference: 8. 66 to 12. 6 inches NOTE: If the Index line falls within the OK range (indicated along the upper edge of the cuff) this cuff is suitable for your use. If the Index line falls out of the OK range, contact the Lumiscope Service Dept. (model # 109-235) 6 Measurement · Press the "ON/OFF/START button. · All display symbols will appear for approximately one second before the display returns to "0". · The unit will automatically start to inflate slowly, measuring your blood pressure. During inflation, the changing values of the cuff pressure will be shown on the display. These numbers are for reference only and do not represent your final Blood Pressure reading. · When the pressure reaches your systolic blood pressure, the monitor will exhaust cuff pressure. When the monitor completes the measurement cycle, it will automatically display the systolic, diastolic and pulse readings. · After the measurement value is displayed, press the ON/OFF/START button to turn the monitor off. Subsequent Measurement When a second measurement needs to be made, the time between two measurements should be at least teb minutes. Automatic Power OFF Function If unit is left on after measurement, an "Automatic Power-OFF Function" turns the power off after approximately one minute. To continue with another measurement press the "ON/OFF/START" switch to turn the unit on. Memory Recall Function · Stores the last sixty readings in sequential order (1-60). When sixty-first reading is taken, the oldest recorded measurement (1) is deleted. [. . . ] All implied warranties, including, but not limited to those implied warranties of fitness and merchantability, are limited in the total duration of two years from the original date of purchase. To obtain warranty service on your LumiscopeTM Blood Pressure Meter either hand deliver or mail the entire unit and your dated sales receipt (as proof of purchase), postpaid, along with a certified check or money order in the amount of $15. 00 payable to The LumiscopeTM Company, Inc. , to cover handling. Upon receipt LumiscopeTM will repair or replace, as appropriate, Blood Pressure Meter, and return to you. [. . . ]