User manual LUMISCOPE MODEL 1131

[. . . ] 13 Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 Cautionary Notes . . . . . . . . . . . . . . . . . . . . . . . . . . 15 Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 Introduction Blood pressure measurements determined with Lumiscope Model 1131 are equivalent to those obtained by a trained observer using cuff/stethoscope auscultation method, within the limits prescribed by the American National Standard, Electronic or Automated Sphygmomanometers. [. . . ] Tighten the cuff by pulling the "Index" end of the cuff. If the Index line falls within the OK range, indicated at the edge of the cuff, this cuff suitable for your use. If the Index line falls out the OK range, you may need a special cuff measurement. Please visit www. lumiscope. net contact our service department at 800-672-8293 for more information regarding 3 is of for or 1- 7 Measurement Procedure 1. Press the User-Switching key to select Memory Zone 1 or Memory Zone 2. or After a memory zone is selected, press the measurement in the chosen memory zone. button to reset the monitor so it can start 2. All digits will light up, checking the display functions. The checking procedure will be completed after about 2 seconds. 3. After all symbols appear, the display will show a blinking "0". The monitor is now ready to measure and will automatically inflate the cuff slowly to start measurement. 8 Measurement Procedure 4. When the measurement is completed, the cuff will automatically deflate. Systolic, diastolic and pulse will be shown simultaneously on the LCD screen. The measurement is then automatically stored into the pre-designated memory zone. Note: 1. This monitor automatically switches off approximately 1 minute after last measurement. To interrupt the measurement, simply press any key. The cuff will deflate immediately after any key is pressed. Do not talk or move your arm or hand muscles during measurements. 9 Recalling Values from Memory 1. The Monitor has two Memory Zones (1 and 2). Each zone can store up to 50 measurements. 2. To read memory values from a selected Memory Zone, use the "User-Switching Key" to select a Memory Zone (1 or 2) from which you want to recall values from. Then, press the "M" key, and the values will be shown on the LCD display with an assigned memory sequence number. 3. The monitor will display an average of the previous measurements first. Every new press of the "M" key calls for one set of prior values stored. [. . . ] The unit should not be operated by children so to avoid hazardous situations. If the unit is stored near freezing, allow it to acclimate at room temperature before use. Your Lumiscope Model 1131 is not field serviceable. You should not use any tool to open the device nor should you attempt to adjust anything inside the device. [. . . ]