User manual LUMISCOPE MODEL 1134

[. . . ] Model 1134 AccuRead Blood Pressure Monitor & Clock User Manual Distributed by: The Lumiscope Co. , Inc www. lumiscope. net Repair Department: 1-800-672-8293 Made and Printed In China 2 Table of Contents Introduction Congratulations on your purchase of the new Lumiscope model 1134. This fully-automatic, blood pressure monitor is both easy-to-use and ideally suited for daily measurements. The large display includes systolic blood pressure reading, diastolic blood pressure reading and the pulse rate, all clearly shown at the completion of each reading. 3 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 How This Monitor Works. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Interference signal around the BPM Incorrect measured result 10 Installing the Batteries Correct Measuring Posture 1. Place your elbow on a table so that the cuff is at the same level as your heart. A. ) Note: The level of your heart is slightly below your armpit. Relax your entire body, especially the area between your elbow and fingers. If the cuff is not at the same level as your heart or if you can not keep your arm completely still throughout the reading, use a soft object such as a folded towel to support your arm. B) Do not allow hard objects to come in contact with the wrist cuff. Sit upright in a chair, and take 5-6 deep breaths. Avoid leaning back or crossing your legs while the measurement is being taken. Press down on the latch and lift the cover towards you to open the battery compartment. Insert 4 "AA" batteries as indicated. Make sure to match polarities (+, ­) on the batteries. Replace the battery cover by inserting the two hooks at the bottom into the slot, then push on the top area. Note: Please remove batteries when not in use for an extended period of time. Do not dispose batteries with household garbage. Fig. Plug the AC/DC adapter (6V 500mA), into the jack located at the bottom of this unit. Use only the adapter included with this unit. Remove batteries when using the AC adapter for an extended period of time. (X) Fig. C Note: 12 To apply the cuff Applying the Cuff Applying the Cuff 13 A. Plug the end of the tubing on the cuff into the connector at the base of the monitor. 2~3 cm (0. 8" ~ 1. 2") Main Artery Left Arm D. To have a secure fit, pull the end of the cuff towards you, wrap it over, then press it for closure. If the Index line falls within the OK range, indicated at the edge of the cuff, this cuff is suitable for your use. If the Index line falls out of the OK range, you may need a cuff with larger circumference. This cuff fits arm sizes 9. 2" - 18. 2". B. Remove any clothing that restricts the upper left arm. [. . . ] Before measuring, please wash your hands. When storing this unit, keep it away from direct sunlight, high humidity or dust. Note: If the unit is being stored for a long period of time, please remove the batteries before storing to avoid leaking. Are the batteries exhausted?Have the batteries polarity been positioned correctly? [. . . ]