User manual LUMISCOPE MODEL 5205

[. . . ] Store values in Memory Press " " key to select Memory Zone 1 or 2, then press the Memory key to store the measured values in the selected Memory Zone. Your new model 1140 stores a maximum of 30 measured values per Memory Zone. Recall Memory Use " " key to select a Memory Zone, then press RECALL key to recall prior measured values from that Memory Zone. See Page 23 6 How the 1140 Works Your model 1140 uses the oscillometric method to detect your blood pressure. [. . . ] Make sure the edge of the cuff is about 1 cm from the palm as Fig. In order to insure accurate measurements, fasten the velcro strap securely around your wrist so there is no extra space between the cuff and the wrist as Fig. C Applying the Cuff If the cuff is not wrapped tight enough, the measurement values will be false. The measurement values will be correct even if you wrap the cuff askew. If your physician has diagnosed you with poor circulation on your left arm, carefully place the cuff around your right wrist as shown in Fig. D 16 Correct Measuring Posture Fig. Place your elbow on a table so that the cuff is at the same level as your heart as Fig. Note: Your heart is located slightly below your armpit. Relax your entire body, especially the area between your elbow and fingers. 2. If the cuff is not at the same level as your heart or if you can not keep your arm Fig. B completely still throughout the reading, use a soft object such as folded towel to support your arm as Fig. Once the monitor inflates the cuff to approximately 180 mmHg, measurement will begin. When the measurement is completed, systolic, diastolic and pulse will be shown simultaneously on the LCD screen. Measurement Procedure 21 Note 1: This monitor automatically switches off approximately 3 minutes after last key operation. Note 2: To interrupt the measurement, simply press any key. The cuff will deflate immediately after a key is pressed. Note 3: During the measurement, do not talk or move your arm or hand muscles. This monitor will re-inflate automatically to approximately 220 mmHg if the system detects that your body needs more pressure to measure your blood pressure. 22 Storing Values in and Recalling Values from Memory & 1. The Monitor has two Memory Zones (1 and 2). Each zone can store up to 30 measurements. To store values, use the UserSwitching or Time-Setting Key " " to select a Memory Zone (1 or 2) to store the values in. Then, by pressing the Memory Key " "after the measurement was taken, the values will be stored in the selected Memory Zone. Storing Values in and Recalling Values from Memory 3. To read memory values from a selected Memory Zone, use the User-Switching or TimeSetting Key " " to select a Memory Zone (1 or 2) from which you want to recall values from. Then, press the RECALL key " " and the values will be shown on the LCD display. [. . . ] Therefore, avoid extreme temperatures, humidity, and direct sunlight. Avoid dropping or strongly shocking the main unit, and protect it from dust. Lumiscope shall not be responsible for any type of incidental, consequential, or special damage. All implied warranties, including, but not limited to those implied warranties of fitness and merchantability, are limited in the total duration of two years from the original date of purchase. [. . . ]