User manual LUX ZE3 100-110V

[. . . ] The suction effect can be further reduced by using the air vent on the hose handle. Select the MIN position and keep the air vent open when vacuuming curtains, etc. For vacuuming very dirty floors or when using air-powered equipment, select the MAX position. [. . . ] When the indicator lamp for the dust bag lights, the bag should be replaced and the motor and HEPA filters inspected. When the overheating indicator lamp blinks, the vacuum cleaner stops operating. Replace the dust bag, check the filters and other matters, then verify if the tube/hose is blocked. Let the vacuum cleaner cool down and do not use it for 30 minutes. After this, the vacuum cleaner should be ready for use again. In case the vacuum cleaner does not start after the following measures have been taken, contact your Lux dealer. Set the hard floor position on the nozzle for smooth operation when vacuuming hard floors. Press the lock switch and pull apart the nozzle and tube. Use the hot air exhaust vent to dry shoes, boots, etc. Your Lux vacuum cleaner has double insulation which is why grounding of the appliance is not necessary. The vacuum cleaner should only be used by adults. Safety approved according to IEC 335-1 and 335-2-2. Max power consumption: 1230 W Fan: Two-stage radial fan Connecting voltage: New Zealand 230 V/50 Hz, Australia 240 V/50 Hz Suction power: New Zealand 270 W, Australia 280 W Noise level, vacuum cleaner: 67 dBA Operating radius: 12 m Weight: 7. The optional spray container can be fitted on your Lux vacuum cleaner to paint, water flowers, etc. Use the ZE3 power nozzle for effective vacuuming of carpets and textiles. Connect the power nozzle to the power outlet. [. . . ] Use the ZE3 power nozzle for effective vacuuming of carpets and textiles. Connect the power nozzle to the power outlet. Attach the power nozzle to the hose handle and connect it to the power outlet. [. . . ]