User manual LUX ZE3 230-240V

[. . . ] Keep it in a safe place, wipe away any spillage at once and never leave the door open with detergent in the machine. iron debris, corrosive, acidic or alkaline chemicals must not be washed in this dishwasher. s Avoid opening the door while the machine is running. -3- Description of the appliance Rinse aid dispenser 1 Use of a rinse conditioner will result in cleaner and faster drying of the load, since it helps water and soil to run off. Too much conditioner may result in streakiness, too little may cause white spots. This is enough for 40-70 wash cycles, depending on the dosage setting. When the rinse conditioner level is approaching the bottom of the scale it is time to refill the dispenser. [. . . ] Clear the holes and shake out any food remnants. -4- Controls and programme table All figures are nominal and vary for example due to temperature variations on the inlet water. The figures apply to washing up 5 IEC-settings. o 1 3 2 1 Temperature selector 55° - Button in 65° - Button out Door lock Press the handle down and open the door. Avoid opening the door while the machine is running. If the door is opened and is put standing ajar after a completed programme the dishes will dry faster. 2 Selector knob Turn the programme selector clockwise to the programme start. The ON/OFF switch is built into the programme selector. To isolate the dishwasher from the mains completely, unplug it from the wall socket. During the water heating process, the timer is standing still. 3 Indicator lamp While the programme is in progress, the operating lamp is lit and it goes out when the programme is ready. -5- How to load the dishwasher The illustration shows the machine loaded with five standard place settings. Your own dishes are not likely to be identical to this load, but if you follow the advice below we are sure you will be pleased with the results. q q Always place glasses, cups and bowls upside down. Incline deep dishes (soup plates etc. ) so that the water can run off when drying. Make sure that the dishes do not rest against each other. This is particularly important in regard to the cutlery basket - nested spoons, etc. s Is the filter inside the intake hose blocked?s Is the water pressure too low? The machine will not drain. s Did you open the door before the light went out and the cycle ended?s Are the filters clogged? Dishes not washed satisfactorily. s s s s s s s s s s s Are the baskets too full?Have the dishes not been arranged properly?Not enough detergent has been used or is it unsuitable?Is the rinse conditioner dispenser empty?Is the washing programme selected too gentle?Is the end of the drain hose submersed in waste water (in the sink?) Visible lime deposits or white film on the dishes. The machine is noisy. s Has the rinse aid run out or is too little being used? s Are the dishes rattling against each other?s Is the spray arm knocking against the dishes?s Have the dishes been left too long inside the machine? [. . . ] . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Purchase date. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Technical specifications DIMENSIONS Height Width Depth 460 mm 450 mm 480 mm WEIGHT Net Gross 17 kg 20 kg CAPACITY 5 standard IEC place settings WATER PRESSURES Minimum Maximum 50 kPa (0. 5 bar) 1000 kPa (10 bar) 65° C WATER TEMPERATURE Maximum ELECTRICAL DATA Power supply Fuse Heating element Power rating 220/230 V - 50 Hz 10 A 1200 W 1280 W -9- Unpacking the machine If the machine is damaged If the machine has been damaged during transportation, you should immediately notify the company responsible for delivering it. If you discover any damage, faults or that anything is missing, you should notify the seller immediately. Never leave packaging material in a place where children may play with it. Check that the following accessories are supplied with the dishwasher when you unpack it: q Elbow for discharge hose Protecting the machine against freezing If the machine is kept in a place where the temperature may sometimes fall below 0°C, there is a risk that the small amount of water which remains inside parts of the machine after normal use will freeze and damage it. [. . . ]