User manual LUX ZE3.1 100-110V

[. . . ] Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. s s s s Do not operate the appliance with a damaged filter as this may cause a fire. Do not allow fluff to accumulate around the dryer. SERVICE/REPAIR s These warnings have been provided in the interest of safety. You MUST read them carefully before installing or using the appliance. Under no circumstances should you attempt to repair the machine yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. [. . . ] To prevent this water from Iying in the hose or flowing back into the tumble dryer, it is advisable to drill a small hole (dia. 3 mm) in the lowest point of the hose and to place a small container below it. (See picture, point A). Once connected to the dryer, run the vent hose to the desired outlet point, ensuring that the run's overall length is less than 2 m, and that it contains no more than two bends. As to the outlet itself, if you have decided on a fixed wall/window grille, a good local builder's merchant should be able to supply you with the necessary fittings and installation advice. It is important not to connect the vent hose to, for example, a cooker hood, or a chimney or flue pipe designed to carry the exhaust from a fuel burning appliance. A P0279 P0055 Note that to avoid condensation problems, it is essential that the dryer be fitted with the flexible hose to carry its "exhaust" at least beyond the kitchen units; preferable outside the kitchen. In order to prevent the appliance from overheating, it is important that the steam exhaust is unobstructed. Therefore, in case of a permanent hose fitted to an exterior wall or ceiling, it must be ensured an exhaust capacity of at least 150 m3/h. If the dryer is fitted next to kitchen units, make sure that the vent hose is not squashed. If the hose is partially squashed, drying efficiency will be reduced, resulting in longer drying times and higher energy consumption. If the hose is completely squashed, the safety cut-outs with which the machine is fitted may operate. 6 Door reversal To make it easier to load or unload the laundry the door can be reversed. This operation must be carried out by qualified personnel. WARNING: A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that the cut off plug is disposed of safely. GREEN & YELLOW E 13 A N L BROWN BLUE P1041 CORD CLAMP 8 USE Control panel COTTONS STORE DRY IRON DRY MANGLE DRY 800-1200 800-1200 800-1200 5. 0kg 90-115 75-100 65- 90 min. min. SYNTHETICS 2. 5kg 55- 75 35- 55 25- 45 STORE DRY 2. 0kg 650 30- 40 min. 1. 0kg 25- 30 WT 75 1 23 4 5 1 Programme Chart This will help you to select the correct time for drying. 4 Mains-On Light This lights up when the machine starts operating and goes out at the end of the programme. 2 Low Temperature Button Press this button to reduce the temperature when drying particularly delicate cotton or linen items. In this case you should select a longer drying time. On the programmes for synthetics the temperature is automatically reduced. Therefore it is not necessary to depress this button. 5 Drying Time Selector Dial The selector dial incorporates two drying cycles, one of up to 150 minutes at a high temperature for cotton and linen, and one of up to 100 minutes at a low temperature for synthetic fabrics. To set the machine to the selected time, turn the dial clockwise until the time you want coincides exactly with the pointer. NEVER attempt to turn the dial in an anticlockwise direction. When selecting the drying time, you should remember that it includes a 10 minute cooling phase (position on the dial). This phase should not be shortened, stopped or avoided, as this could cause skin burns or damages to the laundry. Additional drying If at the end of the programme the laundry is still too damp, set the dial for a further period of drying (remembering to take into account the cooling period). 3 Cool Tumbling Button By depressing this button the heat is cut off. [. . . ] To avoid a static charge when drying is completed, use either a fabric softener when you are washing the laundry or a fabric conditioner specifically for tumble dryers. Remove the laundry when the dryer has finished drying. If individual items are still damp after drying, set a brief post-drying time, but at least 20 minutes. This will be necessary particularly for multilayered items (e. g. [. . . ]