User manual M-AUDIO MK-149

[. . . ] Preparation 2-1 Connect the unit with other MIDI equipment you may have: MIDI IN MIDI IN MIDI Sound Module MIDI Keyboard MIDI IN Computer MIDI OUT 2-2 2-3 3. Turn on the POWER switch. Setting the MIDI TRANSMIT Channel There are 16 MIDI transmit channels available. Once you have set the unit's MIDI channel, the unit sends all MIDI messages on this MIDI channel. Be sure to match the channel with the RECEIVE channel of any connected equipment. [. . . ] TRANSPOSE This function allows you to shift the pitch of the unit in semitones. You can transpose the pitch by 24 half steps (12 up, 12 down). The LED shows the current TRANSPOSE value. 7-2 Press the "+" or "-" switch to change the TRANSPOSE value. Each time you press + or -, the keyboard is transposed an additional half step. * Pressing the + and - switches simultaneously resets the pitch to the default value. Note: Turning the power off always resets the shifted pitch to the default value. 8. OCTAVE CHANGE This function allows you to shift the pitch up to two octaves higher or one lower. The LED starts to flash showing the current OCTAVE value. Press the "+" or "-" switch and the pitch will be shifted one octave higher or lower. * Press + and - switches simultaneously to reset the pitch to the default value. Note: if the "+" or "-" switch is not pressed for 5 seconds, the LED will return to show the PROGRAM CHANGE number. Sending a PROGRAM CHANGE number Using the PROGRAM switch and the numeric keys, you can send any MIDI PROGRAM CHANGE from 0-127. The LED starts to flash showing the 9-2 Press the numeric keys to change the PROGRAM CHANGE number. You can also use the "+" or "-" keys to change * if you don't do anything for 5 seconds the LED stops flashing and shows the current PROGRAM CHANGE number. * if the number you press is larger than 127, it will return to the previous PROGRAM CHANGE number. Sending BANK MSB and LSB message 10. You can send any value of MSB or LSB from 0-127. 10-1 Press the CHANNEL and PROGRAM switches simultaneously. The LED starts to flash showing the current value of the LSB. Press the numeric keys to change the LSB value. You can also use the "+" or "-" switches to change the value. 10-2 Press the PROGRAM and MEMORY switches simultaneously. The LED starts to flash showing the current value of the MSB. Press numeric keys to change the MSB value. [. . . ] Note: If you don't do anything for 5 seconds the LED stops flashing and shows the current PROGRAM CHANGE number. 13. RESET-ALL CONTROLLERS This function allows you to send a RESET-ALL CONTROLLERS message to connected equipment. 13-1 Press MEMORY and TRANSPOSE switches simultaneously. GENERAL MIDI MODE RESET This function allows you to send a GENERAL MIDI MODE RESET message. [. . . ]